Chemical Product Identification & Regulatory Data
Official chemical identifiers, CAS numbers, and regulatory compliance information
Basic Product Information
Regulatory Identifiers
Chemical Abstracts Service registry number - unique identifier for chemical substances
Uses Information
Overview
Bis(chloromethyl)ether is a colorless liquid. substance commonly used laboratory chemicals manufacture of substances scientific research and development.
Manage Your Safety Data Sheets
Organize and access your chemical safety data with ease.
GHS Hazard Classification & Safety Warnings
Globally Harmonized System (GHS) hazard pictograms, signal words, and safety classifications
Classification Status
Signal Word
Hazard Classifications
GHS Hazard Pictograms & Safety Symbols
GHS02
GHS06
GHS07
GHS08
GHS (Globally Harmonized System) pictograms indicate specific chemical hazard categories and safety precautions
Hazard Statements
- H225: Highly flammable liquid and vapor
- H301: Toxic if swallowed
- H311: Toxic in contact with skin
- H330: Fatal if inhaled
- H315: Causes skin irritation
- H319: Causes serious eye irritation
- H350: May cause cancer
- H335: May cause respiratory irritation
Precautionary Statements
- P201: Obtain special instructions before use
- P202: Do not handle until all safety precautions have been read and understood
- P210: Keep away from heat/sparks/open flames/hot surfaces. No smoking
- P233: Keep container tightly closed
- P240: Ground/bond container and receiving equipment
- P241: Use explosion-proof electrical/ventilating/lighting equipment
- P242: Use only non-sparking tools
- P243: Take precautionary measures against static discharge
- P260: Do not breathe fumes, mist, spray, vapors
- P264: Wash skin thoroughly after handling
- P270: Do not eat, drink or smoke when using this product
- P271: Use only outdoors or in a well-ventilated area
- P280: Wear protective gloves/protective clothing/eye protection/face protection
- P284: In case of inadequate ventilation wear respiratory protection
- P301+P310: If swallowed: Immediately call a poison center/doctor/ ...
- P302+P352: If on skin: Wash with plenty of soap and water
- P303+P361+P353: If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower
- P304+P340: If inhaled: Remove person to fresh air and keep comfortable for breathing
- P305+P351+P338: If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing
- P308+P313: If exposed or concerned: Get medical advice/attention
- P310: Immediately call a POISON CENTER or doctor/ physician
- P320: Specific treatment is urgent (see supplemental first aid instructions on this label)
- P321: Specific treatment (see supplemental first aid instructions on this label)
- P330: Rinse mouth
- P332+P313: If skin irritation occurs: Get medical advice/attention
- P337+P313: If eye irritation persists: Get medical advice/attention
- P361: Take off immediately all contaminated clothing
- P362+P364: Take off contaminated clothing and wash it before reuse
- P363: Wash contaminated clothing before reuse
- P370+P378: In case of fire: Use dry sand, dry chemical or alcohol-resistant foam to extinguish
- P403+P233: Store in a well-ventilated place. Keep container tightly closed
- P403+P235: Store in a well-ventilated place. Keep cool
- P405: Store locked up
- P501: Dispose of contents/container to an approved waste disposal plant
Chemical Manufacturers & Supply Chain
Authorized suppliers, manufacturers, and distribution network information
SynQuest Laboratories, Inc.
manufacturer
P.O. Box 309, Alachua, FL 32615 - United States of America
US
(386) 462-0788
(386) 462-7097
24/7 Emergency Response & Poison Control
Critical emergency contact numbers for chemical spills, exposure incidents, and medical emergencies
3E Company - Account 10069
(844) 523-4086
Chemical Composition & Hazardous Ingredients
Detailed component analysis, concentration ranges, and hazardous substance identification
Product Type
substanceChemical Components & Hazardous Substances
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Bis(chloromethyl)ether | 542-88-1 | 100% | ⚠️ Hazardous |
Emergency First Aid Measures
Critical first aid procedures for chemical exposure incidents and medical emergencies
🫁 Inhalation Exposure
Remove person to fresh air and keep comfortable for breathing. If not breathing, give artificial respiration. Get immediate medical advice/attention.
🖐️ Skin Contact
Wash with plenty of soap and water. Get immediate medical advice/attention.
👁️ Eye Contact
Immediately flush eyes thoroughly with water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get immediate medical advice/attention.
🍽️ Ingestion/Swallowing
Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Rinse mouth out with water. Get immediate medical advice/attention.
🚨 Immediate Medical Attention Required
Treat symptomatically.
Fire Fighting Measures & Emergency Response
Fire suppression methods, extinguishing media, and firefighting safety procedures
✅ Suitable Extinguishing Media
Alcohol resistant foam. Carbon dioxide. Dry powder. Water spray. Use extinguishing media appropriate for surrounding fire.
⚠️ Specific Fire Hazards
Thermal decomposition generates: Carbon oxides. Hydrogen chloride. : Risk of explosion if heated under confinement. Use water spray or fog for cooling exposed containers. May form flammable/explosive vapor-air mixture.
🔥 Fire Fighting Instructions
In case of fire: Evacuate area. Fight fire remotely due to the risk of explosion.
🛡️ Firefighter Protection Equipment
Wear gas tight chemically protective clothing in combination with self contained breathing apparatus.
Accidental Release Measures & Spill Response
Emergency spill cleanup procedures, containment methods, and environmental protection
🚨 Emergency Procedures
Gas/vapor heavier than air. May accumulate in confined spaces, particularly at or below ground level. Consider the risk of potentially explosive atmospheres. Eliminate every possible source of ignition.
💧 Small Spill Procedures
Take up small spills with dry chemical absorbent. Sweep or shovel spills into appropriate container for disposal.
🌊 Large Spill Procedures
Take up large spills with pump or vacuum and finish with dry chemical absorbent. Use explosion-proof equipment.
🌍 Environmental Precautions
Avoid release to the environment. Notify authorities if product enters sewers or public waters.
🧹 Cleanup Methods
Take up large spills with pump or vacuum and finish with dry chemical absorbent. Use explosion-proof equipment.
Cleanup Materials:
dry chemical absorbent
Related Chemical Substances & Alternative Products
Similar chemicals with comparable safety profiles and industrial applications
Technical Specifications & Material Properties
Physical state, chemical properties, melting point, boiling point, and material characteristics
Safe Handling & Storage Procedures
Industrial handling precautions, storage conditions, and workplace safety requirements
⚠️ Handling Precautions
• Handle empty containers with care because residual vapors are flammable.
• Do not handle until all safety precautions have been read and understood.
• Ensure good ventilation of the work station.
• Do not breathe fumes, mist, spray, vapors.
• Wear personal protective equipment.
• Avoid contact with skin and eyes.
• Keep away from ignition sources (including static discharges).
• Proper grounding procedures to avoid static electricity should be followed.
• Use only non-sparking tools.
🏪 Storage Conditions
• Keep container closed when not in use.
• Store in dry, well-ventilated area.
🧼 General Hygiene Measures
Handle in accordance with good industrial hygiene and safety procedures. Do not eat, drink or smoke when using this product. Always wash hands after handling the product.
🔥 Fire Prevention Measures
Keep away from ignition sources.
Exposure Controls & Personal Protective Equipment (PPE)
Occupational exposure limits, engineering controls, and required safety equipment
🏭 Engineering Controls
Ensure good ventilation of the work station. Emergency eye wash fountains and safety showers should be available in the immediate vicinity of any potential exposure.
🧤 Hand Protection
Protective gloves. 29 CFR 1910.138: Hand Protection.
👁️ Eye Protection
Chemical goggles or safety glasses. Face shield. 29 CFR 1910.133: Eye and Face Protection.
😷 Respiratory Protection
In case of inadequate ventilation wear respiratory protection. 29 CFR 1910.134: Respiratory Protection.
🦺 Skin/Body Protection
Wear suitable protective clothing.
Chemical Stability & Reactivity Data
Chemical stability, hazardous reactions, and incompatible materials information
✅ Chemical Stability
The product is stable at normal handling and storage conditions.
🚫 Conditions to Avoid
Keep away from heat, sparks and flame.
🧪 Incompatible Materials
Strong acids. Strong oxidizing agents.
💨 Hazardous Decomposition Products
Under normal conditions of storage and use, hazardous decomposition products should not be produced. Hazardous decomposition products in case of fire, see Section 5.
Ecological Information & Environmental Impact
Environmental toxicity, biodegradation, bioaccumulation, and ecological effects data
🌱 Toxicity
🌱 Persistence and degradability
🌱 Bioaccumulative potential
🌱 Mobility in soil
🌱 Other adverse effects
Waste Disposal & Treatment Methods
Waste disposal procedures, treatment methods, and regulatory compliance requirements
♻️ Waste Treatment Methods
Remove to an authorized incinerator equipped with an afterburner and a flue gas scrubber.
🗂️ Product Disposal Recommendations
Dispose of contents/container in accordance with licensed collector's sorting instructions. : Recycle the material as far as possible.
Transportation & Shipping Information
UN numbers, shipping names, transport classes, and regulatory transport requirements
🏷️ UN Number
UN2249
📦 Proper Shipping Name
Dichlorodimethyl ether, symmetrical
⚠️ Transport Hazard Class
6.1 - Class 6.1 - Poisonous materials 49 CFR 173.132
📋 Packing Group
I
Regulatory Information & Compliance
Chemical regulations, safety assessments, and regulatory compliance status
📋 Regulatory Summary
All components of this product are listed, or excluded from listing, on the United States Environmental Protection Agency Toxic Substances Control Act (TSCA) inventory.
❌ Chemical Safety Assessment
No chemical safety assessment has been performed for this substance.
ℹ️ Additional Regulatory Information
Chemical(s) subject to the reporting requirements of Section 313 or Title III of the Superfund Amendments and Reauthorization Act (SARA) of 1986 and 40 CFR Part 372.
Chemical Safety FAQ & Common Questions
Most frequently asked questions about safety, handling, storage, and regulatory compliance
What is the hazard signal word for Bis(chloromethyl)ether?
The signal word for this substance is "danger".
What is the physical form of Bis(chloromethyl)ether?
Bis(chloromethyl)ether is a liquid appearing as colorless liquid. with colorless color. It has suffocating odor.
What is the solubility of Bis(chloromethyl)ether?
No data available
What is Bis(chloromethyl)ether used for?
Laboratory chemicals Manufacture of substances Scientific research and development
What are the hazard statements for Bis(chloromethyl)ether?
This substance has 8 hazard statements: H225: Highly flammable liquid and vapor H301: Toxic if swallowed H311: Toxic in contact with skin H330: Fatal if inhaled H315: Causes skin irritation H319: Causes serious eye irritation H350: May cause cancer H335: May cause respiratory irritation
What is the melting point of Bis(chloromethyl)ether?
The melting point is - 41.5 ℃ and the boiling point is 106 ℃.