Liebherr Motoroil 10W-40

Supply fresh air.

Immediately wash with water and soap and rinse thoroughly. Remove contaminated clothing.

Rinse opened eye for several minutes under running water. If persistent irritation occurs, obtain medical attention.

Do not induce vomiting; immediately call for medical help. Do not induce vomiting. If vomiting occurs spontaneously, keep head below hips to prevent aspiration.

CO2, sand, extinguishing powder. Use fire fighting measures that suit the environment.

Do not use water with full jet.

Formation of toxic gases is possible during heating or in case of fire.

Particular danger of slipping on leaks or spills of this product.

Do not allow to enter sewers, surface or ground water. Prevent from spreading (e.g. by damming-in or oil barriers).

Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust).

Materials: sand, diatomite, acid binders, universal binders, sawdust

Avoid prolonged or repeated contact with skin. Avoid inhaling vapour and/or mists. Store in cool, dry place in tightly closed containers.

Store in cool, dry place in tightly closed containers. Store only in the original container. Store away from foodstuffs, oxidizing agents, and water.

No special measures required.

No further data; see section 7.

Where hand contact with the product may occur the use of gloves approved to relevant standards (ASTM F 739) made from fluorcarbon rubber (Viton) or nitrile rubber may provide suitable chemical protection. Suitability, penetration time of substances and durability of a glove is dependent on usage, e.g. frequency and duration of contact, chemical resistance of glove material, glove thickness and dexterity. Always seek advice from glove supplier. Protective gloves will deteriorate over time due to physical and chemical damage. Inspect and replace gloves on a regular basis. The frequency of replacement will depend upon circumstances of use. Consult with manufacturer of the gloves in case of long term exposure. Preventive skin protection by use of skin-protecting agents is recommended.

Safety glasses with side shields recommended during refilling or if splashes are likely to occur.

No respiratory protection is ordinarily required under normal conditions of use. Select a filter suitable for combined particulate/ gases and organic vapours (boiling point > 65 °C, EN 14387), if exposure limit is exceeded or when aerosol or mist is formed.

Protective work clothing.

Stable at normal conditions.

See 10.2 to 10.6

Reacts with strong oxidizing agents.

Avoid contact with heat, sparks, flame and all other sources of ignition. No specific data available.

No further relevant information available.

No dangerous decomposition products known.

All recovered material should be packaged, labeled, transported and disposed or reclaimed in conformance with Good Engineering Practices. Comply with all applicable governmental regulations. Avoid land filling. Reclaim where possible.

Must not be disposed together with household garbage. Do not allow product to reach sewage system. Contact waste processors for recycling information. Delivery of waste oil/product to officially authorized collectors only. Disposal of product and packaging must be made according to official regulations (state, federal or local). Incinerate or dispose of in accordance with existing federal, state or local environmental regulations.