Base Oil Ultra-S3 (70 Neutral)

Move person to fresh air immediately. If breathing has stopped, apply artificial respiration and administer oxygen if necessary.

Remove and wash contaminated clothing and shoes. Wash exposed portions of the skin with soap and water.

Symptoms: Prolonged or frequent skin contact may cause various skin disorders such as dermatitis, oil acne, skin redness and edema.

Flush eyes with large amounts of water for 15 minutes while holding eyelids open. Seek medical attention.

Seek medical attention.

Symptoms: Ingestion may cause gastrointestinal irritation, nausea, vomiting and diarrhea.

Foam, Dry chemical, Carbon dioxide

Combustible material, low hazard. The product can form flammable mixtures or can burn only on heating above the flash point. However, minor contamination by hydrocarbons of higher volatility may increase the hazard.

Do not enter confined fire space without protective equipment including NIOSH approved self-contained breathing apparatus. Use water only to cool fire exposed containers.

Remove with vacuum trucks or by pumping into storage facilities. Soak up residue with absorbent such as vermiculite. Dispose of absorbent and contaminated soil in the same manner as the product. Flush areas into chemical sewer to remove residual. Provide adequate ventilation during clean-up.

Remove with vacuum trucks or by pumping into storage facilities.

Do not empty into drains.

Fill materials taken up into disposable container. Remove with vacuum trucks or by pumping into storage facilities. Soak up residue with absorbent such as vermiculite.

The protective measures as usual in the mineral oil industry have to be observed. Provide suitable mechanical equipment for the safe handling of drums and heavy packages. Keep containers closed when not in use. Prevent small spillage and leakage to avoid slip hazard.

Store in dry place at room temperature.

The protective measures as usual in the mineral oil industry have to be observed.

Adequate ventilation in accordance with good engineering practice must be provided to keep any oil mist concentration below the PEL.

Use chemical-resistant gloves, if needed.

Wear chemical goggles to prevent eye contact.

Not required under normal usage. If product is handled in such a way as to create a vapor or mist, a NIOSH approved respirator should be used to prevent overexposure. In accordance with 29 CFR 1910.134, use either a full-face, atmosphere-supplying respirator or an air-purifying respirator for organic vapors.

Stable under normal ambient.

None known.

Will not occur.

None known.

Avoid contact with strong oxidants such as liquid chlorine and concentrated oxygen.

Product does not decompose at ambient temperature. Products evolved when subjected to heat or combustion : Carbon monoxide, carbon dioxide, aldehides & ketones, combustion products of nitrogen and sulfur.

Place contaminated materials in disposable containers and dispose of in a manner consistent with applicable regulation.

Waste materials should be dumped or buried in an approved industrial waste landfill. Large quantities may be disposed of by incineration in a suitable combustion chamber.