NextSDS Logo
Safety Data Sheet EN

1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine

Scan your chemical compliance

Free 10-second scan. Upload a document and check compliance instantly.

Scan Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine
Product Code
850757C

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Laboratory chemicals, Manufacture of substances

Manufacturers & Suppliers

S

Sigma-Aldrich BVBA/SPRL

national supplier

Pegasuslaan 5 B-1831 DIEGEM

+32 (0)3 899-1301

Emergency Contacts

CHEMTREC

+(32) 28 083237

Anti-poison centre

070 245245

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Acute Tox. Cat. 4 H302
Acute Tox. Cat. 3 H331
Skin Irrit. Cat. 2 H315
Eye Irrit. Cat. 2 H319
Carc. Cat. 2 H351
Repr. Cat. 2 H361
STOT SE Cat. 3 H336
STOT RE Cat. 1 H372

GHS Pictograms

GHS06 - Acute toxicity

GHS06

GHS08 - Serious health hazard

GHS08

Hazard Statements

H302 Harmful if swallowed.
H315 Causes skin irritation.
H319 Causes serious eye irritation.
H331 Toxic if inhaled.
H336 May cause drowsiness or dizziness.
H351 Suspected of causing cancer.
H361 Suspected of damaging the unborn child.
H372 Causes damage to organs through prolonged or repeated exposure.

Precautionary Statements

P201 Obtain special instructions before use.
P260 Do not breathe dust/ fume/ gas/ mist/ vapours/ spray.
P264 Wash skin thoroughly after handling.
P280 Wear protective gloves/ protective clothing/ eye protection/ face protection.
P304 + P340 + P311 IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER/doctor.
P403 + P233 Store in a well-ventilated place. Keep container tightly closed.

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

Synonyms : 16:0-18:1 PE

Chemical Name CAS Number Concentration Hazardous
Chloroform EC: 200-663-8 67-66-3 90 - 100% Yes

Notes

For the full text of the H-Statements mentioned in this Section, see Section 16.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

If breathed in, move person into fresh air. If not breathing, give artificial respiration. Consult a physician.

Skin contact

Wash off with soap and plenty of water. Take victim immediately to hospital. Consult a physician.

Eye contact

Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician.

Ingestion

Never give anything by mouth to an unconscious person. Rinse mouth with water. Consult a physician.

Immediate Medical Attention

No data available

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

The data for this section has not been processed yet.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

The data for this section has not been processed yet.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

The data for this section has not been processed yet.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Hands

Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique (without touching glove's outer surface) to avoid skin contact with this product. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Wash and dry hands. The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it.

Eyes

Face shield and safety glasses Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).

Respiratory

Where risk assessment shows air-purifying respirators are appropriate use a fullface respirator with multi-purpose combination (US) or type ABEK (EN 14387) respirator cartridges as a backup to engineering controls. If the respirator is the sole means of protection, use a full-face supplied air respirator. Use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU).

Skin/Body

Complete suit protecting against chemicals, The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace.

Environmental

Prevent further leakage or spillage if safe to do so. Do not let product enter drains. Discharge into the environment must be avoided.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
liquid
Physical State Data
liquid
State Under Standard Conditions
---
Solubility In Water
No data available
Partition Coefficient
No data available
Crystallisation Point
---
Relative Density
1,49 g/cm3
Explosive Limits
---
Density
---
Vapor Pressure
No data available
Voc Content
---
Kinematic Viscosity
---
Form
liquid
Ph
No data available
Dynamic Viscosity
---
Appearance
---
Solubility
---
Lower Explosive Limit
No data available
Softening Point
---
Flash Point
No data available
Vapor Density
No data available
Evaporation Rate
No data available
Bulk Density
---
Solubility In Fat
---
Colour
---
Freezing Point
No data available
Decomposition Temperature
No data available
Cloud Point
---
Colour Intensity
---
Odor Threshold
No data available
Properties Status
---
Auto Ignition Temperature
No data available
Melting Point
No data available
Relative Evaporation Rate
---
Upper Explosive Limit
No data available
Solidification Point
---
Molecular Weight
---
Odor
No data available
Flammability
No data available
Metal Corrosion
---
Boiling Point
No data available
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under recommended storage conditions. Contains the following stabiliser(s): Ethanol (0,5 %)

Reactivity

No data available

Hazardous reactions

No data available

Avoid

No data available

Incompatible

Strong oxidizing agents

Decomposition

Hazardous decomposition products formed under fire conditions. - Carbon oxides, Nitrogen oxides (NOx), Oxides of phosphorus, Hydrogen chloride gas Other decomposition products - No data available

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
1888
Shipping Name
CHLOROFORM, SOLUTION
Transport Class
6.1
Packing Group
III
ADR

No data available

IMDG

No data available

IATA

No data available

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine?

The signal word is danger.

What is the physical form of 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine?

1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine is a liquid . It has no data available odor.

What is 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine used for?

Laboratory chemicals, Manufacture of substances

What are the hazard statements for 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine?

This substance has 8 hazard statements:

  • H302: Harmful if swallowed.
  • H315: Causes skin irritation.
  • H319: Causes serious eye irritation.
  • H331: Toxic if inhaled.
  • H336: May cause drowsiness or dizziness.
  • H351: Suspected of causing cancer.
  • H361: Suspected of damaging the unborn child.
  • H372: Causes damage to organs through prolonged or repeated exposure.

What is the melting point of 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphoethanolamine?

The melting point is No data available and the boiling point is No data available.

Compliance Scanner

Scan your compliance