CHARBONNEL VERNIS GRAVEUR ULTRAFLEX / LIQUID GROUND ENGRAVER ULTRAFLEX

Move the exposed person to fresh air at once. When breathing is difficult, properly trained personnel may assist affected person by administering oxygen. Get medical attention.

Symptoms: Vapours may cause headache, fatigue, dizziness and nausea.

Remove affected person from source of contamination. Remove contaminated clothing immediately and wash skin with soap and water.

Symptoms: Prolonged contact may cause redness, irritation and dry skin.

Promptly wash eyes with plenty of water while lifting the eye lids. Continue to rinse for at least 15 minutes. Get medical attention promptly if symptoms occur after washing.

Symptoms: May cause severe irritation to eyes.

NEVER MAKE AN UNCONSCIOUS PERSON VOMIT OR DRINK FLUIDS! If vomiting occurs, keep head low so that stomach content doesn't get into the lungs. Get medical attention.

Symptoms: May cause stomach pain or vomiting. Drowsiness, dizziness, disorientation, vertigo.

Water spray, fog or mist. Foam. Carbon dioxide (CO2). Dry chemicals, sand, dolomite etc.

Do not use water jet as an extinguisher, as this will spread the fire.

Oxidizes readily in air to unstable peroxides that may explode spontaneously. May explode when heated or when exposed to flames or sparks. May travel considerable distance to source of ignition and flash back.

Move container from fire area if it can be done without risk. Cool containers exposed to flames with water until well after the fire is out. For massive fire in cargo area, use unmanned hose holder or monitor nozzles, if possible. If not, withdraw and let fire burn out.

Ventilate well, stop flow of gas or liquid if possible. Avoid contact with skin or inhalation of spillage, dust or vapour.

Prevent discharge of larger quantity to drain.

Do not discharge into drains, water courses or onto the ground.

Absorb spillage with non-combustible, absorbent material.

Materials: non-combustible, absorbent material

Keep away from heat, sparks and open flame. Avoid spilling, skin and eye contact. Ventilate well, avoid breathing vapours. Use approved respirator if air contamination is above accepted level.

Keep away from heat, sparks and open flame. Store in a cool and well-ventilated place.

Avoid spilling, skin and eye contact.

Keep away from heat, sparks and open flame. Ground container and transfer equipment to eliminate static electric sparks.

Provide adequate general and local exhaust ventilation.

For exposure of 4 to 8 hours use gloves made of: Polyvinyl alcohol (PVA). P.T.F.E (Teflon).

Wear approved chemical safety goggles where eye exposure is reasonably probable.

Wear appropriate clothing to prevent any possibility of skin contact.

Avoid oxidisers. Light.

Hazardous Polymerisation. May polymerise.

Avoid heat, flames and other sources of ignition.

Oxides of: Carbon.

Dispose of waste and residues in accordance with local authority requirements.