NextSDS Logo
Safety Data Sheet EN

EP2 GREASE

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
EP2 GREASE
Product Code
XGE003, XGE125, XGE400, XGE500, QHE500

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Grease.

Manufacturers & Suppliers

T

TETROSYL LIMITED

national supplier

Bury: Lancashire, England, BL9 7NY

T

TETROSYL LIMITED

manufacturer

Bury: Lancashire, England, BL9 7NY

Emergency Contacts

Emergency Contact

+44 (0)161 764 5981

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified no signal word

Hazard Classifications

Not Classified
Not Classified
Not Classified

GHS Pictograms

Hazard Statements

Not Classified

Precautionary Statements

P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

The data for this section has not been processed yet.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

If spray/mist has been inhaled, proceed as follows. Move affected person to fresh air and keep warm and at rest in a position comfortable for breathing.

Symptoms: May cause an asthma-like shortness of breath. Vapours may cause headache, fatigue, dizziness and nausea.

Skin contact

Remove contaminated clothing immediately and wash skin with soap and water. Rinse with water. Get medical attention if any discomfort continues.

Symptoms: Skin irritation. Prolonged or repeated contact with skin may cause irritation, redness and dermatitis. Blistering may occur.

Eye contact

Get medical attention promptly if symptoms occur after washing. Rinse immediately with plenty of water. Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes. Do not rub eye.

Symptoms: Irritating to eyes. Symptoms following overexposure may include the following: Redness. Pain. May cause blurred vision and serious eye damage.

Ingestion

Rinse mouth thoroughly with water. Give plenty of water to drink. Get medical attention if a large quantity has been ingested. Show this Safety Data Sheet to the medical personnel.

Symptoms: May cause discomfort if swallowed. May cause stomach pain or vomiting.

Immediate Medical Attention

Get medical attention if any discomfort continues. Get medical attention if a large quantity has been ingested. Get medical attention promptly if symptoms occur after washing.

Medical Treatment

No specific recommendations. If in doubt, get medical attention promptly.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Foam, carbon dioxide or dry powder. Use fire-extinguishing media suitable for the surrounding fire.

Specific hazards

No unusual fire or explosion hazards noted.

Firefighter Protection

No specific firefighting precautions known.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

In case of spills, beware of slippery floors and surfaces. Avoid contact with skin and eyes. Stop leak if possible without risk.

Environmental

Avoid discharge into drains or watercourses or onto the ground.

Cleanup methods

Absorb spillage with non-combustible, absorbent material. Collect and place in suitable waste disposal containers and seal securely.

Materials: non-combustible, absorbent material

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid contact with skin and eyes. Do not handle broken packages without protective equipment.

Storage

Keep containers upright. Store in tightly-closed, original container.

Hygiene

Good personal hygiene procedures should be implemented. Wash hands and any other contaminated areas of the body with soap and water before leaving the work site. Do not eat, drink or smoke when using the product.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Provide adequate ventilation. Avoid inhalation of vapours. Observe any occupational exposure limits for the product or ingredients.

Hands

Chemical-resistant, impervious gloves complying with an approved standard should be worn if a risk assessment indicates skin contact is possible. It is recommended that gloves are made of the following material: Nitrile rubber. It should be noted that liquid may penetrate the gloves. Frequent changes are recommended.

Eyes

Eyewear complying with an approved standard should be worn if a risk assessment indicates eye contact is possible. Unless the assessment indicates a higher degree of protection is required, the following protection should be worn: Tight-fitting safety glasses.

Respiratory

No specific recommendations. Respiratory protection may be required if excessive airborne contamination occurs.

Skin/Body

Wear suitable protective clothing as protection against splashing or contamination.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Appearance
Grease.
Colour
Dark brown.
Odor
Characteristic.
Freezing Point
---
Density
---
Odor Threshold
---
Explosive Limits
---
Relative Evaporation Rate
Not determined.
Crystallisation Point
---
Softening Point
---
Solidification Point
---
Kinematic Viscosity
---
Vapor Pressure
Not determined.
Form
---
Solubility In Fat
---
Solubility
Insoluble in water.
Ph
Not determined.
Evaporation Rate
Not determined.
Vapor Density
Not determined.
Colour Intensity
---
Lower Explosive Limit
Not determined.
Auto Ignition Temperature
>250°C
Physical State Data
liquid
Boiling Point
>250°C @ 1.013 hPa
Dynamic Viscosity
>30,000 cP @ 20°C
Bulk Density
---
Flammability
---
Melting Point
Not determined.
Physical State
Grease
Solubility In Water
Insoluble in water.
Cloud Point
---
Upper Explosive Limit
Not determined.
Flash Point
>150°C
Partition Coefficient
Not determined.
Relative Density
0.900g/cm³ @ 20°C
Voc Content
---
Decomposition Temperature
Not determined.
Metal Corrosion
---
Molecular Weight
---
Properties Status
---
State Under Standard Conditions
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

No particular stability concerns.

Reactivity

There are no known reactivity hazards associated with this product.

Hazardous reactions

Not applicable.

Avoid

There are no known conditions that are likely to result in a hazardous situation.

Incompatible

Alkali metals. No specific material or group of materials is likely to react with the product to produce a hazardous situation.

Decomposition

Does not decompose when used and stored as recommended.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Treatment

Dispose of waste to licensed waste disposal site in accordance with the requirements of the local Waste Disposal Authority.

Disposal

Waste should be treated as controlled waste. Dispose of waste to licensed waste disposal site in accordance with the requirements of the local Waste Disposal Authority.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

Transport Class
No transport warning sign required.
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

Chemical Safety Assessment Not performed
?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for EP2 GREASE?

The signal word is no signal word.

What is the physical form of EP2 GREASE?

EP2 GREASE is a grease appearing as grease. with dark brown. color. It has characteristic. odor.

What is the solubility of EP2 GREASE?

Insoluble in water.

What is EP2 GREASE used for?

Grease.

What are the hazard statements for EP2 GREASE?

This substance has 1 hazard statement:

  • Not Classified

What is the melting point of EP2 GREASE?

The melting point is Not determined. and the boiling point is >250°C @ 1.013 hPa.