DA EZ DRAIN

Move to fresh air. If not breathing, give artificial respiration. Get medical attention immediately.

Symptoms: Inhalation may result in irritation or burns to the respiratory tract.

Remove immediately all contaminated clothing. Wash off immediately with plenty of water for at least 15 minutes. Get medical attention immediately.

Symptoms: Corrosive, Causes burns and possible deep ulcerations or scarring.

In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention immediately.

Symptoms: Corrosive. Causes burns and may lead to corneal damage and possible blindness.

Never give anything by mouth to an unconscious person. Drink 1 or 2 glasses of water. Do NOT induce vomiting. Get medical attention immediately. Show the Label to the Doctor.

Symptoms: Ingestion may result in severe burns to the mouth, throat and digestive tract.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. Use:. Water spray. Foam. Carbon dioxide (CO2). Dry chemical.

Water jet.

Thermal decomposition can lead to release of irritating gases and vapours. Sulphur oxides.

Avoid contact with skin, eyes, and clothing. Use personal protective equipment. Prevent further leakage or spillage if safe to do so. Material can create slippery conditions. Ventilate the area. Refer to protective measures listed in sections 7 and 8.

No special environmental precautions required.

Clean preferably with a detergent, do not use solvents.

Avoid contact with skin, eyes and clothing. Avoid breathing vapours or mists. Do not eat, drink or smoke when using this product. Training : Due to the hazardous nature of this product, training in its use is recommended.

Store in original container. Keep containers tightly closed in a dry, cool and well-ventilated place.

Do not eat, drink or smoke when using this product.

Ensure adequate ventilation, especially in confined areas.

Wear suitable protective gloves conforming to EN 374. Type of gloves suggested: Short term use eg occasional contact or splash protection; Nitrile rubber (0.4 mm). Long term use eg continuous wear or immersion; Solvent-resistant gloves (butyl-rubber). Fluorinated rubber. Suitability and durability of a glove is dependent upon usage factors such as frequency, duration of use, temperature and chemical resistance. The use of a chemical-protective glove may in practice be much shorter than the permeation time determined through testing. For break through times, refer to glove manufacturers recommendations.

Tightly fitting safety goggles. Approved to EN 166. For large volumes, faceshields should be used.

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Conforming to EN 143 - P2 / P3 Particle filters. In case of mist, spray or aerosol exposure wear suitable personal respiratory protection and protective suit.

Body protection must be chosen based on activity and possible exposure, e.g. footwear (solid shoes, rubber boots), rubber apron, long-sleeved work clothing, impervious suit.

Stable under normal conditions.

See further information below.

The mixture itself will not dangerously react or polymerise to create hazardous conditions in normal use.

Protect from water. Reacts with most metals to produce flammable hydrogen gas.

Water. Bases. Reducing agents. Contact with specific metals may liberate Hydrogen gas eg Aluminium, Zinc. Chlorine-based bleaching agents.

None under normal storage conditions and use. Thermal decomposition can lead to release of irritating gases and vapours. Sulphur oxides.

Dispose of in accordance with local regulations.

Dispose of in accordance with local regulations.

No special precautions.

No special precautions.

No special precautions.