Santoflex(TM) 6PPD Liquid

Remove person to fresh air and keep comfortable for breathing. If breathing is difficult, give oxygen. Consult a physician if necessary.

Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes. If skin irritation or rash occurs: Get medical advice/ attention. Wash contaminated clothing before reuse. Cool skin rapidly with cold water after contact with molten material. Do not peel solidified product off the skin. Burns must be treated by a physician.

Symptoms: Skin irritation or rash, burns, allergic skin reaction.

In case of contact, immediately flush eyes with plenty of water for at least 15 minutes.

Rinse mouth. Get medical attention if symptoms occur. Do not induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person.

Water spray Foam Dry powder Carbon dioxide (CO2)

Do not use a solid water stream as it may scatter and spread fire.

In case of fire and/or explosion do not breathe fumes.

Wear appropriate personal protective equipment. Avoid prolonged or repeated contact with skin. Avoid breathing dust/ fume/ gas/ mist/ vapours/ spray. Ensure adequate ventilation. Material can create slippery conditions. Local authorities should be advised if significant spillages cannot be contained.

Prevent further leakage or spillage if safe to do so. Avoid release to the environment. Collect spillage.

Contain spillage, soak up with non-combustible absorbent material, and transfer to a container for disposal according to local / national regulations (see section 13).

Materials: sand, earth, diatomaceous earth, vermiculite

Wear appropriate personal protective equipment. Avoid breathing dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing should not be allowed out of the workplace.

Keep containers tightly closed in a dry, cool and well-ventilated place.

Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing should not be allowed out of the workplace.

Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.

For prolonged or repeated contact use protective gloves. After contamination with product change the gloves immediately and dispose of them according to relevant national and local regulations. When handling hot material, use heat resistant gloves.

Safety eyewear complying with an approved standard should be used when a risk assessment indicates this is necessary to avoid exposure to liquid splashes, mists, gases or dusts. Wear safety glasses with side shields (or goggles).

If engineering controls do not maintain airborne concentrations below recommended exposure limits (where applicable) or to an acceptable level (in countries where exposure limits have not been established), an approved respirator must be worn.

Personal protective equipment for the body should be selected based on the task being performed and the risks involved and should be approved by a specialist before handling this product. Remove and wash contaminated clothing before re-use.

Stable under normal conditions.

None reasonably foreseeable.

None known.

Heating in air.

Strong acids Strong oxidizing agents

Emits acrid smoke and fumes when heated to decomposition.