NextSDS Logo
Safety Data Sheet EN

Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash

Scan your chemical compliance

Free 10-second scan. Upload a document and check compliance instantly.

Scan Now
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash
Product Code
MS0800307

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Industrial/Institutional Kitchen hygiene product This product is intended to be diluted prior to use

Uses advised against

Uses other than those identified are not recommended

Manufacturers & Suppliers

Diversey, Inc. logo

Diversey, Inc.

manufacturer

1300 Altura Rd., Suite 125 Fort Mill, SC 29708

1-888-352-2249

https://sds.diversey.com

D

Diversey Canada, Inc.

manufacturer

6150 Kennedy Road Unit 3 Mississauga, Ontario L5T 2J4

1-800-668-7171

Emergency Contacts

Emergency Contact

1-800-851-7145

Emergency Contact

1-651-917-6133

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Skin Corr. Cat. 1B
Eye Dam. Cat. 1
Met. Corr. Cat. 1

GHS Pictograms

GHS05 - Corrosive

GHS05

Hazard Statements

H290 MAY BE CORROSIVE TO METALS.
CAUSES SEVERE SKIN BURNS AND SERIOUS EYE DAMAGE.

Precautionary Statements

Causes burns/ serious damage to mouth, throat and stomach.
Keep container tightly closed.
Keep only in original container.
Avoid contact with eyes, skin and clothing.
Wash affected areas thoroughly after handling.
Wear protective gloves, protective clothing and eye or face protection.
IF SWALLOWED: Rinse mouth. DO NOT induce vomiting unless directed to do so by medical personnel. Drink a cupful of milk or water.
IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water for at least 15 minutes. Wash contaminated clothing before reuse.
IF INHALED: Remove person to fresh air and keep comfortable for breathing.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing for at least 15 minutes.
Immediately call a Poison Center (1-800-851-7145) or physician.
Absorb spillage to prevent material damage.
Store in corrosive-resistant container with a resistant inner liner.
Dispose of in accordance with all federal, state and local applicable regulations.

Manage your Safety Data Sheets

Organize and access chemical safety data with ease

Manage SDS
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Lactic acid 79-33-4 15 - 40% Yes
Phosphoric acid 7664-38-2 10 - 30% Yes
Sodium Lauryl Sulfate 151-21-3 0.1 - 1% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

IF INHALED: Remove person to fresh air and keep comfortable for breathing.

Skin contact

IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water for at least 15 minutes.

Eye contact

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing for at least 15 minutes.

Ingestion

IF SWALLOWED: Rinse mouth. DO NOT induce vomiting unless directed to do so by medical personnel. Drink a cupful of milk or water. Call a Poison Center (1-800-851-7145) or doctor/physician if you feel unwell.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

The product is not flammable. Extinguish fire using agent suitable for surrounding fire.

Unsuitable media

No information available.

Specific hazards

Corrosive material (See sections 8 and 10).

Instructions

No special methods required

Firefighter Protection

As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Large spill

Absorb spill with inert material (e.g. dry sand or earth), then place in a chemical waste container. Use a water rinse for final clean-up.

Environmental

Clean-up methods - large spillage.

Cleanup methods

Absorb spill with inert material (e.g. dry sand or earth), then place in a chemical waste container. Use a water rinse for final clean-up.

Materials: inert material (e.g. dry sand or earth)

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Can react to release hazardous gases. Do not mix with other products or chemicals except as directed on the label. Mix only with water. Avoid contact with skin, eyes and clothing. Do not taste or swallow. Product residue may remain on/in empty containers. All precautions for handling the product must be used in handling the empty container and residue. Avoid breathing vapors or mists.

Storage

Store in corrosive-resistant container with a resistant inner liner.

Hygiene

Wash thoroughly after handling. Remove and wash contaminated clothing and footwear before re-use.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

Good general ventilation should be sufficient to control airborne levels.

Hands

Chemical-resistant gloves.

Eyes

Chemical-splash goggles.

Respiratory

No personal protective equipment required under normal use conditions. If aerosols, mists, or vapors are not adequately controlled by ventilation, use appropriate respiratory protection to avoid over-exposure.

Skin/Body

If major exposure is possible, wear suitable protective clothing and footwear.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Auto Ignition Temperature
No information available
Dynamic Viscosity
---
Lower Explosive Limit
Not determined
Relative Evaporation Rate
---
Odor Threshold
No information available.
Softening Point
---
Voc Content
0 % *
Molecular Weight
---
Form
---
Solubility
Completely Soluble
Freezing Point
Not determined
Properties Status
---
Relative Density
1.30
Physical State
Liquid
Crystallisation Point
---
Solubility In Water
---
Melting Point
Not determined
Vapor Pressure
No information available.
Metal Corrosion
Metal corrosive
Colour Intensity
---
Partition Coefficient
No information available
Bulk Density
No information available
Explosive Limits
---
Decomposition Temperature
Not determined
Colour
Clear, Yellow
Physical State Data
liquid
Solidification Point
---
Appearance
---
Flash Point
> 200.1 °F > 93.4 °C
Cloud Point
---
Upper Explosive Limit
Not determined
Density
1.2956 Kg/L
Kinematic Viscosity
No information available
Ph
< 2
Vapor Density
No information available
Boiling Point
Not determined
Evaporation Rate
No information available
Odor
Characteristic
State Under Standard Conditions
---
Solubility In Fat
---
Flammability
Not applicable
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

The product is stable

Reactivity

Not Applicable

Hazardous reactions

May vigorously react with strong alkaline products resulting in spattering and excessive heat.

Avoid

None known.

Incompatible

Strong bases. Ammonia. Do not mix with chlorinated products (such as bleach). Do not mix with any other product or chemical unless specified in the use directions.

Decomposition

None reasonably foreseeable.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN1805
Shipping Name
PHOSPHORIC ACID SOLUTION
Transport Class
8
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash?

The signal word is danger.

What is the physical form of Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash?

Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash is a liquid with clear, yellow color. It has characteristic odor.

What is the solubility of Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash?

Completely Soluble

What is Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash used for?

Industrial/Institutional Kitchen hygiene product This product is intended to be diluted prior to use

What are the hazard statements for Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash?

This substance has 2 hazard statements:

  • H290: MAY BE CORROSIVE TO METALS.
  • CAUSES SEVERE SKIN BURNS AND SERIOUS EYE DAMAGE.

What is the melting point of Suma®Eden™/MC D4.5 Antimicrobial Fruit and Vegetable Wash?

The melting point is Not determined and the boiling point is Not determined.

Compliance Scanner

Scan your compliance