Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- UV 75 - PATEX UV 75
Regulatory Identifiers
- CAS Number
- N/A
Manufacturers & Suppliers
SARP SRL
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
GHS Pictograms
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Phenol,2- (2H-benzotriazol-2-yl) -6-dodecyl-4-methyl EC: 401-680-5 | 23328-53-2 | 40 - 42.5% | Yes |
| sebacato di bis(1,2,2,6,6-pentametil-4-piperidile) EC: 255-437-1 | 41556-26-7 | 30 - 32.5% | Yes |
| miscela di isomeri di: 3-(3,5-di-terz-butil-4-idrossifenil)propionato di C7-9-alchile EC: 406-040-9 | 125643-61-0 | 19.5 - 21% | Yes |
| Sebacato di metile e 1,2,2,6,6-pentametil-4-piperidile EC: 280-060-4 | 82919-37-7 | 9 - 10.5% | Yes |
First Aid Measures
Emergency procedures for chemical exposure incidents
Remove to open air. If breathing is irregular, seek medical advice.
Wash immediately with plenty of water. Remove contaminated clothing. If irritation persists, seek medical attention. Wash contaminated clothing before using them again.
Irrigate copiously with clean, fresh water for at least 15 minutes. Seek medical advice.
Obtain immediate medical attention. Induce vomiting only if indicated by the doctor. Never give anything by mouth to an unconscious person.
Immediate Medical Attention
Obtain immediate medical attention.
Medical Treatment
Follow doctor's orders.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
carbon dioxide, foam, powder and nebulised water.
None in particular.
Do not breathe combustion products (carbon oxide, toxic pyrolysis products, etc).
Use jets of water to cool the containers to prevent product decomposition and the development of substances potentially hazardous for health.
Firefighter Protection
Always wear full fire prevention gear.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
The product must not penetrate the sewers, surface water, ground water and neighbouring areas.
Collect as much material as possible and eliminate the rest using jets of water.
Related Products
Similar products with comparable safety profiles
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
Avoid bunching of electrostatic charges. Do not smoke. Do not spray on flames or sparks. Vapours may catch fire and an explosion may occur; vapours accumulation is therefore to be avoided by leaving windows and doors open and ensuring a good ventilation (draught). Without adequate ventilation, vapours may accumulate on the floor (low layers) and catch fire even at a distance, if ignited, with the danger of backfire.
Store in a place where adequate ventilation is ensured, away from direct sunlight at a temperature below 50 °C, far from any combustion sources.
Do not smoke. Do not spray on flames or sparks. Avoid bunching of electrostatic charges. Far from any combustion sources.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
make sure that the workplace is well aired through effective local aspiration or bad air vent.
Protect hands with category II (ref. Directive 89/686/EEC and standard EN 374) work gloves, such as those in PVC, neoprene, nitryl or equivalent. The following should be considered when choosing work glove material: degradation, breakage times and permeation. Work glove resistance to preparations should be checked before use, as it can be unpredictable. Gloves' limit depends on the duration of exposure.
Wear protective airtight goggles (ref. standard EN 166).
If the threshold value for one or more of the substances present in the preparation for daily exposure in the workplace or to a fraction established by the company's prevention and protection service is exceeded, wear a mask with an B or universal filter, the class (1, 2 or 3) of which must be chosen according to the limit concentration of use (ref. standard EN 141). The use of breathing protection equipment, such as masks with organic vapour and dust/mist cartridges, is necessary in the absence of technical measures limiting worker exposure. The protection provided by masks is in any case limited. If the substance in question is odourless or its olfactory threshold is higher than the relative exposure limit and in the event of an emergency, or when exposure levels are unknown or the concentration of oxygen in the workplace is less than 17% volume, wear self-contained, open-circuit compressed air breathing apparatus (ref. standard EN 137) or fresh air hose breathing apparatus for use with full face mask, half mask or mouthpiece (ref. standard EN 138).
Wear category II professional long-sleeved overalls and safety footwear (ref. Directive 89/686/CEE and standard EN 344).
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
The product is stable in normal conditions of use and storage.
There are no particular risks of reaction with other substances in normal conditions of use.
No hazardous reactions are foreseeable in normal conditions of use and storage.
None in particular, however the usual precautions used for chemical products should be respected.
Information not available.
In the event of thermal decomposition or fire, vapours potentially dangerous to health may be released.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- UN Number
- 3082
- Shipping Name
- ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S.
- Transport Class
- 9
- Packing Group
- III
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for UV 75 - PATEX UV 75?
The signal word is no signal word.
What is the physical form of UV 75 - PATEX UV 75?
UV 75 - PATEX UV 75 is a liquid appearing as liquid with yellow color. It has mild odor.
What is the solubility of UV 75 - PATEX UV 75?
<0,01%(m) a 20°C
What is the melting point of UV 75 - PATEX UV 75?
The melting point is Not available. and the boiling point is 200 °C..