EMKARATE™ RL 32-3MAF

Remove exposed person to fresh air if adverse effects are observed.

Wash with soap and water. If skin irritation occurs, get medical attention. Launder contaminated clothing before reuse. Wash with soap and water. If skin irritation occurs, get medical attention.

Any material that contacts the eye should be washed out immediately with water. If easy to do, remove contact lenses.

Treat symptomatically. Get medical attention.

CO2, Dry chemical or Foam. Water can be used to cool and protect exposed material. CO2, dry chemical, foam, water spray, water fog.

Do not use water jet as an extinguisher, as this will spread the fire.

Keep away from heat, sparks and open flame. Water may cause splattering. Container may rupture on heating.

No data available.

Ventilate area if spilled in confined space or other poorly ventilated areas.

Dike far ahead of larger spill for later recovery and disposal.

Avoid release to the environment. Do not contaminate water sources or sewer. Environmental manager must be informed of all major spillages. Prevent further leakage or spillage if safe to do so.

Pick up free liquid for recycle and/or disposal. Residual liquid can be absorbed on inert material.

Materials: inert material

Keep away from ignition sources such as heat, sparks and open flame. No smoking. Keep containers closed when not in use. Wash thoroughly after handling. Launder contaminated clothing before reuse. Empty container contains product residue which may exhibit hazards of product.

Store away from incompatible materials.

Observe good industrial hygiene practices. Wash thoroughly after handling. Launder contaminated clothing before reuse.

Keep away from ignition sources such as heat, sparks and open flame. No smoking.

Use material in well ventilated area only. Adequate ventilation should be provided so that exposure limits are not exceeded. Mechanical ventilation or local exhaust ventilation may be required.

Rubber (natural, latex). Polyvinyl chloride (PVC). Nitrile. For typical use and handling of chemical substances, gloves should meet the standards set out in EN 374. For applications involving mechanical risks with potential for abrasion or puncture, the standards set out in EN 388 should be considered. For continuous contact, we suggest gloves with a minimum breakthrough time of 240 minutes, or > 480 minutes if suitable gloves can be obtained. For general applications, we recommend gloves with a thickness typically greater than 0.35 mm.

If contact is likely, safety glasses with side shields are recommended. Eye protection should meet the standards set out in EN 166.

Use self-contained breathing apparatus for entry into confined space, for other poorly ventilated areas and for large spill clean-up sites. Use respirator with an organic vapor cartridge if exposure limit is exceeded. Respiratory Protective Equipment (RPE) is not normally required where there is adequate natural or local exhaust ventilation to control exposure. In case of insufficient ventilation, wear suitable respiratory equipment.

Long sleeve shirt is recommended. Wear apron or protective clothing in case of contact.

No data available. See section 6 for details.

Material is stable under normal conditions.

No data available.

Will not occur.

Do not expose to excessive heat, ignition sources, or oxidizing materials.

Strong oxidizing agents.

Thermal decomposition or combustion may generate smoke, carbon monoxide, carbon dioxide, and other products of incomplete combustion.