ECO Leak Finder

Remove person to fresh air and keep comfortable for breathing. If signs/symptoms develop, get medical attention.

Wash skin with plenty of water. Seek medical attention if irritation develops.

Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Seek medical attention if irritation develops.

Symptoms: Eye irritation.

Call a poison center or a doctor if you feel unwell.

Water spray. Dry powder. Foam. Carbon dioxide.

Do not use a heavy water stream.

Move containers from fire area if it can be done without personal risk. Use standard firefighting procedures and consider the hazards of other involved materials.

For non-emergency personnel: Ventilate spillage area. Avoid contact with skin and eyes. For emergency responders: Evacuate unnecessary personnel. Ventilate area.

Take up small spills with dry chemical absorbent.

For large spills, confine the spill in a dike and charge it with wet sand or earth for subsequent safe disposal. Following product recovery, flush area with water.

Avoid release to the environment.

Clean surface thoroughly to remove residual contamination.

Materials: dry chemical absorbent

Ensure good ventilation of the work station. Avoid contact with skin and eyes. Wear personal protective equipment. Avoid prolonged exposure. Handle in accordance with good industrial hygiene and safety procedures.

Store in a well-ventilated place. Keep cool. Keep container closed when not in use.

Do not eat, drink or smoke when using this product. Always wash hands after handling the product.

Good general ventilation should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level.

Wear suitable gloves tested to EN374. The breakthrough time of the glove should be longer than the total duration of product use. If work lasts longer than the breakthrough time, gloves should be changed part-way through. Neoprene gloves are recommended.

Use eye protection according to EN 166. Safety glasses with side shields.

In case of insufficient ventilation, wear suitable respiratory equipment. Approved organic vapour respirator. Filter type: A

Wear suitable protective clothing

Avoid release to the environment. Emissions from ventilation or work process equipment should be checked to ensure they comply with the requirements of environmental protection legislation.

Stable under normal conditions.

The product is non-reactive under normal conditions of use, storage and transport.

No dangerous reactions known under normal conditions of use.

None under recommended storage and handling conditions (see section 7). Avoid temperatures exceeding the flash point.

Strong oxidizing agents.

Under normal conditions of storage and use, hazardous decomposition products should not be produced. Carbon oxides (CO, CO2).