MacCONKEY AGAR No3

Move to fresh air. Get medical attention if symptoms occur..

Wash off with warm water and soap. If symptoms persist, call a physician.

Rinse thoroughly with plenty of water, also under the eyelids. If eye irritation persists, consult a specialist.

Clean mouth with water and drink afterwards plenty of water. Obtain medical attention.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment

No information available.

Thermal decomposition can lead to release of irritating gases and vapors

Ensure adequate ventilation. Avoid dust formation. Avoid contact with the skin and the eyes.

Prevent further leakage or spillage if safe to do so

Sweep up or vacuum up spillage

Materials: suitable container

Ensure adequate ventilation. Do not breathe dust. Avoid contact with skin and eyes.

Keep container tightly closed in a dry and well-ventilated place. Protect from moisture.

Avoid contact with skin and eyes.

Ensure adequate ventilation, especially in confined areas. Wherever possible, engineering control measures such as the isolation or enclosure of the process, the introduction of process or equipment changes to minimise release or contact, and the use of properly designed ventilation systems, should be adopted to control hazardous materials at source.

Protective gloves. Glove material: Disposable gloves. Breakthrough time: See manufacturers recommendations. Glove thickness: -. EU standard: EN 374. (minimum requirement). Inspect gloves before use. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. (Refer to manufacturer/supplier for information). Ensure gloves are suitable for the task: Chemical compatability, Dexterity, Operational conditions, User susceptibility, e.g. sensitisation effects, also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. Remove gloves with care avoiding skin contamination.

Safety glasses with side-shields (European standard - EN 166)

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. To protect the wearer, respiratory protective equipment must be the correct fit and be used and maintained properly. Large scale/emergency use: In case of insufficient ventilation wear suitable respiratory equipment. Small scale/Laboratory use: Use a NIOSH/MSHA or European Standard EN 149:2001 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. When RPE is used a face piece Fit Test should be conducted.

Long sleeved clothing

No information available.

Stable under recommended storage conditions. Hygroscopic.

None known, based on information available.

Hazardous polymerization does not occur. None under normal processing.

Heat, flames and sparks, Keep away from direct sunlight.

Strong oxidizing agents.

None under normal use conditions

Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste. Consult local, regional, and national hazardous waste regulations to ensure complete and accurate classification.

Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste.