4-Aminobenzoic acid

Remove to fresh air. If not breathing, give artificial respiration. Get medical attention if symptoms occur.

Symptoms: trouble breathing, dizziness, lightheadedness

Wash off immediately with plenty of water for at least 15 minutes. If skin irritation persists, call a physician.

Symptoms: rash, itching, swelling, tingling of the hands and feet

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.

Clean mouth with water and drink afterwards plenty of water. Get medical attention if symptoms occur.

Water spray, carbon dioxide (CO2), dry chemical, alcohol-resistant foam.

No information available.

Dust can form an explosive mixture with air. Fine dust dispersed in air may ignite.

Ensure adequate ventilation. Use personal protective equipment as required. Avoid dust formation.

Should not be released into the environment.

Sweep up and shovel into suitable containers for disposal.

Materials: suitable containers

Wear personal protective equipment/face protection. Ensure adequate ventilation. Do not get in eyes, on skin, or on clothing. Avoid ingestion and inhalation. Avoid dust formation.

Store under an inert atmosphere. Protect from direct sunlight. Keep refrigerated.

Handle in accordance with good industrial hygiene and safety practice.

Ensure adequate ventilation, especially in confined areas. Ensure that eyewash stations and safety showers are close to the workstation location. Wherever possible, engineering control measures such as the isolation or enclosure of the process, the introduction of process or equipment changes to minimise release or contact, and the use of properly designed ventilation systems, should be adopted to control hazardous materials at source

Protective gloves. Glove material: Nitrile rubber, Neoprene, Natural rubber, PVC, Butyl rubber. Breakthrough time: See manufacturers recommendations. EU standard: EN 374. Glove comments: (minimum requirement)

Goggles (European standard - EN 166)

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. To protect the wearer, respiratory protective equipment must be the correct fit and be used and maintained properly. Large scale/emergency use: Use a NIOSH/MSHA or European Standard EN 136 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. Recommended Filter type: Particulates filter conforming to EN 143. Small scale/Laboratory use: Use a NIOSH/MSHA or European Standard EN 149:2001 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. Recommended half mask:- Particle filtering: EN149:2001; Valve filtering: EN405; or; Half mask: EN140; plus filter, EN 141. When RPE is used a face piece Fit Test should be conducted

Long sleeved clothing. Inspect gloves before use. observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. (Refer to manufacturer/supplier for information) gloves are suitable for the task: Chemical compatibility, Dexterity, Operational conditions, User susceptibility, e.g. sensitisation effects, also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. gloves with care avoiding skin contamination.

Prevent product from entering drains.

Air sensitive. Light sensitive.

Yes

Hazardous polymerization does not occur. None under normal processing.

Incompatible products. Excess heat. Avoid dust formation. Exposure to air. Exposure to light.

Strong oxidizing agents.

Nitrogen oxides (NOx). Carbon monoxide (CO). Carbon dioxide (CO₂).