Concentrated and prediluted solutions of conjugated monoclonal or polyclonal antibodies in aqueous Tris-base antibody stabilization solution (NaN3 <0.01%)

Move person into fresh air and keep at rest. Get medical attention if any discomfort continues. If breathing stops, provide artificial respiration. Get medical attention immediately!

Symptoms: May cause coughing or mild irritation

Remove contaminated clothing immediately and wash skin with soap and water. Get medical attention promptly if symptoms occur after washing. Generally, the product does not irritate the skin.

Symptoms: Prolonged skin contact may cause redness and irritation

Promptly wash eyes with plenty of water while lifting the eye lids. Make sure to remove any contact lenses from the eyes before rinsing. Continue to rinse for at least 15 minutes. Obtain medical attention and bring these instructions.

Symptoms: May cause temporary eye irritation

Immediately rinse mouth and drink plenty of water (200-300 ml). DO NOT INDUCE VOMITING! NEVER MAKE AN UNCONSCIOUS PERSON VOMIT OR DRINK FLUIDS! Get medical attention.

Symptoms: May cause discomfort if swallowed

Water spray. Alcohol resistance Foam, Powder.

The product is non-combustible. If heated, irritating vapors may be formed. Hydrogen chloride (HCl). When heated and in case of fire, very toxic nitrogen oxides (NOx) are formed.

Minimize direct contact with skin or eyes and prevent inhalation. Stop leak if possible without any risk.

Prevent further leakage or spillage if safe to do so. Do not allow it to enter drains, sewers or watercourses.

Collect spillage in suitable waste containers, seal securely and deliver for disposal according to local regulations. Flush with plenty of water to clean spillage area.

Materials: suitable waste containers

Provide adequate ventilation, including appropriate local extraction, to ensure that the defined occupational exposure limit is not exceeded. Avoid inhalation of vapors/spray and contact with skin and eyes. Wash contaminated clothing before reuse. For precautions see section 2.

Store in a tightly closed original container in a dry, cool and well-ventilated place. Refer to product label.

Wash contaminated clothing before reuse.

Provide adequate ventilation. Observe occupational exposure limits and minimize the risk of inhalation of spray.

Use suitable chemical resistant protective gloves if risk of skin contact. The most suitable glove must be chosen in consultation with the glove's supplier, who can inform you about the breakthrough time of the glove material. Frequent change is advisable. Latex or Nitrile gloves; thickness 0.11 mm, ASTM F1671, DIN EN 374 or equivalent; AQL 1.5.

If there is a risk of splashing, wear safety goggles or face shield. DIN 166 or equivalent.

No specific recommendation made, but if risk assessment shows air purifying respirators are appropriate, use masks with approved filter. Use only devices approved by competent authorities like NIOSH (USA) and CEN (EU). Respiratory protection must be used if the general level exceeds the recommended occupational exposure limit.

Wear apron or protective clothing in case of contact. Wash contaminated clothing before reuse. Wash thoroughly after handling.

Prevent further leakage or spillage if safe to do so. Do not let product enter drains.

Stable under normal temperature conditions.

There are no known reactivity hazard for these concentrations when handling the product according to its intended use.

Dangerous reactions are not to be expected for these concentrations when handling the product according to its intended use. Will not polymerize.

Avoid exposure to fire, static electricity, or direct sunlight.

Strong oxidizers, strong acids or alkalis.

None known.

Sodium Azide may react with lead and copper plumbing to form explosive metal azides.

Sodium Azide may react with lead and copper plumbing to form explosive metal azides.

Sodium Azide may react with lead and copper plumbing to form explosive metal azides.