Special Ink Jet Cleaner for water removable ink

Remove to fresh air, keep patient warm and at rest, if breathing is irregular or stopped, administer artificial respiration. Give nothing by mouth. If unconscious place in recovery position and seek medical advice.

Remove contaminated clothing. Wash skin thoroughly with soap and water or use recognised skin cleanser. Do not use solvents or thinners.

Remove contact lenses, irrigate copiously with clean, fresh water for at least 10 minutes, holding the eyelids apart and seek medical advice.

If accidentally swallowed obtain immediate medical attention. Keep at rest. Do not induce vomiting.

alcohol resistant foam, CO2, powders, waterspray

waterjet

Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard.

Cool closed containers exposed to fire with water.

Exclude sources of ignition and ventilate the area. Avoid breathing vapours.

Do not allow to enter drains or watercourses.

Clean preferably with a detergent; avoid use of solvents.

Materials: detergent

Vapours are heavier than air and may spread along floors. Vapours may form explosive mixtures with air. Prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentration higher than the occupational exposure limits. Avoid skin and eye contact. Avoid inhalation of dust, particulates and spray mist arising from the application of this preparation. Avoid inhalation of dust from sanding. Never use pressure to empty: container is not a pressure vessel.

Store between 15 and 25 °C in a dry, well ventilated place away from sources of heat and direct sunlight.

Smoking, eating and drinking should be prohibited in application area.

Keep away from sources of ignition. Isolate from sources of heat, sparks and open flame. No sparking tools should be used.

Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction.

If these are not sufficient to maintain concentrations of particulates and solvent vapour below the OEL, suitable respiratory protection must be worn.

Stable under recommended storage and handling conditions

Keep away from oxidising agents, strongly alkaline and strongly acid materials in order to avoid exothermic reactions.

high temperatures

oxidising agents, strongly alkaline and strongly acid materials

carbon monoxide and dioxide, smoke, oxides of nitrogen etc.