NextSDS Logo
Safety Data Sheet EN

LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H
Product Code
1382539

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Epoxy Hardener

Uses advised against

None identified

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way, Rocky Hill, Connecticut 06067

+1 (860) 571-5100

www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Acute Tox. Cat. 4
Skin Corr. Cat. 1
Eye Dam. Cat. 1
Skin Sens. Cat. 1
Carc. Cat. 2

GHS Pictograms

GHS05 - Corrosive

GHS05

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H302 HARMFUL IF SWALLOWED.
H314 CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
H317 MAY CAUSE AN ALLERGIC SKIN REACTION.
H351 SUSPECTED OF CAUSING CANCER.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P261 Avoid breathing mist/vapours.
P264 Wash affected area thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P272 Contaminated work clothing should not be allowed out of the workplace.
P280 Wear protective gloves, clothing, eye and face protection.
P301 + P330 + P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P303 + P361 + P353 If on skin (or hair): Take off immediately all contaminated clothing.
P304 + P340 + P310 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Immediately call a POISON CENTER or physician.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P308 + P313 IF exposed or concerned: Get medical attention.
P333 + P313 If skin irritation or rash occurs: Get medical attention.
P362 + P364 Take off contaminated clothing and wash it before reuse.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.
IF SWALLOWED: Call a POISON CENTER or doctor/ physician if you feel unwell. Rinse mouth.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
4-Methylimidazole 822-36-6 5 - 10% Yes
Tetraethylene pentamine 112-57-2 1 - 5% Yes
3,6-diazaoctanethylenediamine 112-24-3 0.1 - 1% Yes
3,6,9,12-tetraazatetradecamethylenediamine 4067-16-7 0.1 - 1% Yes

* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Move to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.

Skin contact

Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. Get medical attention. Wash clothing before reuse.

Eye contact

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.

Ingestion

Do not induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention.

Immediate Medical Attention

Get medical attention.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water spray (fog), foam, dry chemical or carbon dioxide.

Unsuitable media

Not available.

Specific hazards

Closed containers may rupture (due to build up of pressure) when exposed to extreme heat.

Instructions

In case of fire, keep containers cool with water spray.

Firefighter Protection

Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Isolate area. Keep unnecessary personnel away.

Environmental

Do not allow product to enter sewer or waterways.

Cleanup methods

Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust).

Materials: sand, silica gel, acid binder, universal binder, sawdust

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Use only with adequate ventilation. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Do not taste or swallow.

Storage

Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightly closed until ready for use.

Hygiene

Wash thoroughly after handling.

Fire prevention

Keep away from heat, sparks and open flame.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Softening Point
---
Solidification Point
---
Melting Point
Not applicable, Product is a liquid
Auto Ignition Temperature
Not available.
Form
---
Colour
Light yellow
Freezing Point
---
Relative Density
1
Partition Coefficient
Not available.
Dynamic Viscosity
Not available.
Physical State Data
liquid
Evaporation Rate
Not applicable
Appearance
---
Odor Threshold
Not available.
Explosive Limits
---
Bulk Density
---
Cloud Point
---
Relative Evaporation Rate
---
Physical State
Liquid
Molecular Weight
---
Solubility In Fat
---
Solubility In Water
---
Kinematic Viscosity
2 mm2/s
Crystallisation Point
---
Lower Explosive Limit
Not available.
Decomposition Temperature
340 °C
Colour Intensity
---
Metal Corrosion
---
Odor
Ammoniacal
Density
---
Solubility
Soluble Water
Flash Point
> 93 °C (> 199.4 °F) Closed cup
Properties Status
---
Upper Explosive Limit
Not available.
Boiling Point
> 260 °C (> 500°F)
Ph
11
Vapor Density
---
State Under Standard Conditions
---
Flammability
The product is not flammable.
Vapor Pressure
< 13 hPa (20 °C (68°F))
Voc Content
< 0.1 % (by weight)
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal conditions of storage and use.

Reactivity

Not available.

Hazardous reactions

None under normal processing.

Avoid

High temperatures. Heat, flames, sparks and other sources of ignition. Store away from incompatible materials.

Incompatible

Strong oxidizing agents. Strong acids and strong bases.

Decomposition

Oxides of carbon. Oxides of nitrogen. Irritating vapors. Ammonia.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
3267
Shipping Name
Corrosive liquid, basic, organic, n.o.s. (Imidazole, Tetraethylene pentamine)
Transport Class
8
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H?

The signal word is danger.

What is the physical form of LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H?

LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H is a liquid with light yellow color. It has ammoniacal odor.

What is the solubility of LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H?

Soluble Water

What is LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H used for?

Epoxy Hardener

What are the hazard statements for LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H?

This substance has 4 hazard statements:

  • H302: HARMFUL IF SWALLOWED.
  • H314: CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
  • H317: MAY CAUSE AN ALLERGIC SKIN REACTION.
  • H351: SUSPECTED OF CAUSING CANCER.

What is the melting point of LOCTITE ECCOBOND F 123-H known as TRACON F 123 BIPAX 2,42 GR - H?

The melting point is Not applicable, Product is a liquid and the boiling point is > 260 °C (> 500°F).