TECHNOMELT PW 867

If not breathing, give artificial respiration. If breathing is difficult, oxygen should be administered by qualified personnel. Move to fresh air. If symptoms persist, seek medical advice.

Cool skin rapidly with cold water after contact with molten material. Cover affected areas with clean sheeting or gauze and seek immediate medical attention. No attempt should be made to remove material from skin or to remove contaminated clothing as damaged skin can be easily torn.

Symptoms: Molten adhesive may cause severe burns.

If eye contact occurs with molten material immediately cool with water. Do not remove adhesive. Seek medical attention.

If symptoms develop and persist, get medical attention.

Use extinguishing measures appropriate to local circumstances and the surrounding environment. Dry chemical. Carbon dioxide.

Not available.

Fire fighters should wear positive pressure self-contained breathing apparatus (SCBA). Wear full protective clothing.

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

No special environmental precautions required. Do not allow material to contaminate ground water system.

Spilled material will solidify. Scrape up spilled material and place in a closed container for disposal.

Always be careful around molten material. Avoid skin contact with molten resins. Follow suggested application temperature. Do not wear contact lenses. At elevated temperatures, irritating fumes may be emitted. Wash hands before breaks and immediately after handling the product.

store between 0.0 °C (32°F) and 38.0 °C (100.4 °F)

Wash hands before breaks and immediately after handling the product.

Work should be done in an adequately ventilated area (i.e., ventilation sufficient to maintain concentrations below one half of the PEL and other relevant standards). Local exhaust ventilation is recommended when general ventilation is not sufficient to control airborne contamination.

Insulated gloves are strongly recommended when working with molten adhesive.

Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists. Do not wear contact lenses.

No personal respiratory protective equipment normally required. Where the potential exists for exposure to decomposition products due to heating or elevated temperatures, wear NIOSH approved respiratory protection as appropriate. Observe OSHA regulations for respirator use (29 CFR 1910.134).

long sleeved clothing are strongly recommended when working with molten adhesive.

Stable

Not available.

Will not occur.

To avoid thermal decomposition, do not overheat. Avoid temperatures above 200°C (392°F).

Oxidizing agents.

Thermal decomposition can lead to release of irritating gases and vapors. carbon monoxide carbon dioxide