Identification
Product identifiers, regulatory numbers, and supplier information
Product Information
- Product Name
- LOCTITE FREKOTE R110
- Product Form
- Mold Release
- Product Code
- 2820794
Regulatory Identifiers
- CAS Number
- N/A
Manufacturers & Suppliers
Henkel Corporation
manufacturer
One Henkel Way, Rocky Hill, Connecticut 06067
+1 (860) 571-5100
www.henkelna.com
Emergency Contacts
Poison Control Center
1-877-671-4608
Poison Control Center
1-303-592-1711
CHEMTREC
1-800-424-9300
CHEMTREC
1-703-527-3887
Hazard Identification
GHS classification, signal word, pictograms, and hazard statements
Hazard Classifications
GHS Pictograms
GHS07
Hazard Statements
Precautionary Statements
Get a free compliance audit
Upload your SDS inventory and get a detailed compliance report
Composition / Information on Ingredients
Chemical components, concentration ranges, and hazardous substance identification
| Chemical Name | CAS Number | Concentration | Hazardous |
|---|---|---|---|
| Triethoxy(methyl)silane | 2031-67-6 | 1 - 5% | Yes |
IDH number: 2820794 Product name: LOCTITE FREKOTE R110
Notes
* Exact percentages may vary or are trade secret. Concentration range is provided to assist users in providing appropriate protections.
First Aid Measures
Emergency procedures for chemical exposure incidents
Move to fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. Get medical attention.
Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. If symptoms develop and persist, get medical attention.
Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.
DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention.
Firefighting Measures
Extinguishing media, specific hazards, and firefighter protection
Not applicable. Product is an aqueous dispersion.
Not available.
Closed containers may rupture (due to build up of pressure) when exposed to extreme heat.
Wear protective equipment.
Accidental Release Measures
Spill cleanup procedures, containment, and environmental protection
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Evacuate and ventilate spill area; dike spill to prevent entry into water system; wear full protective equipment during clean-up.
Do not allow product to enter sewer or waterways. Prevent further leakage or spillage if safe to do so.
Wet surfaces may be slippery. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Store in a partly filled, closed container until disposal.
Materials: inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust)
Related Products
Similar products with comparable safety profiles
LOCTITE FREKOTE PMC
---
LOCTITE FREKOTE 4368G known as FREKOTE 4368G DR
---
LOCTITE FREKOTE PMC 190L
---
LOCTITE FREKOTE AC4368 known as FREKOTE AC4368 5 GA PA
---
LOCTITE FREKOTE 55NC 5L CN
---
LOCTITE FREKOTE 55 NC DES.
---
LOCTITE FREKOTE R-120 known as FREKOTE AQUALINE R-120 AEROSOL
---
LOCTITE FREKOTE REL-EAZE known as FREKOTE® Rel-Eaze™
---
Handling and Storage
Safe handling precautions, storage conditions, and workplace requirements
For operations where eye or face contact could occur, provide safety shower and eyewash fountain. Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Do not wear contact lenses. Use only with adequate ventilation.
Keep in a cool, well ventilated area. Keep container closed. Store in original container until ready to use.
Wash thoroughly after handling. Do not wear contact lenses.
Exposure Controls / PPE
Occupational exposure limits, engineering controls, and protective equipment
Use explosion-proof mechanical ventilation and local exhaust to control contaminants to within their occupational exposure limits during the use of this product.
Use chemical resistant, impermeable gloves.
Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists.
Use a NIOSH approved supplied air respirator with an organic cartridge if the potential to exceed established exposure limits exists.
Use chemical resistant, impermeable clothing including an apron or body suit to prevent skin contact.
Physical and Chemical Properties
Appearance, physical state, melting point, boiling point, and material characteristics
Stability and Reactivity
Chemical stability, hazardous reactions, and incompatible materials
Stable under normal conditions of storage and use.
Not available.
None under normal processing.
Store away from incompatible materials.
Avoid contact with materials sensitive to water.
Oxides of carbon. Irritating organic vapours.
Ecological Information
Environmental toxicity, biodegradation, and bioaccumulation data
The data for this section has not been processed yet.
Disposal Considerations
Waste treatment methods, disposal recommendations, and waste codes
The data for this section has not been processed yet.
Transport Information
UN numbers, shipping names, transport classes, and regulatory requirements
- Shipping Name
- Not regulated
Regulatory Information
Chemical regulations, safety assessments, and compliance status
The data for this section has not been processed yet.
Frequently Asked Questions
Common questions about safety, handling, and properties
What is the hazard signal word for LOCTITE FREKOTE R110?
The signal word is warning.
What is the physical form of LOCTITE FREKOTE R110?
LOCTITE FREKOTE R110 is a liquid with white, off white color. It has mild odor.
What is the solubility of LOCTITE FREKOTE R110?
emulsifiable Water, Soluble Water
What are the hazard statements for LOCTITE FREKOTE R110?
This substance has 1 hazard statement:
- H319: CAUSES SERIOUS EYE IRRITATION.
What is the melting point of LOCTITE FREKOTE R110?
The melting point is Not applicable and the boiling point is 100 °C (212°F)1,013 hPano method / method unknown 100 °C (212°F).