NextSDS Logo
Safety Data Sheet EN

BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Conversion coating

Manufacturers & Suppliers

Henkel Corporation logo

Henkel Corporation

manufacturer

One Henkel Way Rocky Hill, Connecticut 06067

+1 (860) 571-5100

http://www.henkelna.com

Emergency Contacts

Poison Control Center

1-877-671-4608

Poison Control Center

1-303-592-1711

CHEMTREC

1-800-424-9300

CHEMTREC

1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Carc. Cat. 1A
OXIDIZING LIQUID Cat. 2
Skin Corr. Cat. 1
Eye Dam. Cat. 1
Resp. Sens. Cat. 1
Skin Sens. Cat. 1
Muta. Cat. 2
Repr. Cat. 1B
STOT RE Cat. 1

GHS Pictograms

GHS03 - Oxidizing

GHS03

GHS05 - Corrosive

GHS05

GHS08 - Serious health hazard

GHS08

Hazard Statements

H272 MAY INTENSIFY FIRE; OXIDIZER.
H314 CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
H317 MAY CAUSE AN ALLERGIC SKIN REACTION.
H334 MAY CAUSE ALLERGY OR ASTHMA SYMPTOMS OR BREATHING DIFFICULTIES IF INHALED.
H341 SUSPECTED OF CAUSING GENETIC DEFECTS.
H350 MAY CAUSE CANCER.
H360 MAY DAMAGE FERTILITY OR THE UNBORN CHILD.
H372 CAUSES DAMAGE TO ORGANS THROUGH PROLONGED OR REPEATED EXPOSURE.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P210 Keep away from heat, sparks, open flames, hot surfaces - no smoking.
P260 Do not breathe vapors, mist, or spray.
P264 Wash affected area thoroughly after handling.
P270 Do not eat, drink or smoke when using this product.
P272 Contaminated work clothing should not be allowed out of the workplace.
P280 Wear protective gloves, clothing, eye and face protection.
P284 [In case of inadequate ventilation] wear respiratory protection.
P301 + P330 + P331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P303 + P361 + P353 If on skin (or hair): Take off immediately all contaminated clothing.
P304 + P340 + P310 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. Immediately call a POISON CENTER or physician.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P308 + P313 IF exposed or concerned: Get medical attention.
P333 + P313 If skin irritation or rash occurs: Get medical attention.
P342 + P311 If experiencing respiratory symptoms: Call a poison center or physician.
P362 + P364 Take off contaminated clothing and wash it before reuse.
P370 + P378 In case of fire: Use foam, dry chemical or carbon dioxide to extinguish.
P405 Store locked up.
P501 Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations.
Keep away from clothing and other combustible materials.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture
Chemical Name CAS Number Concentration Hazardous
Zinc dihydrogen phosphate 13598-37-3 5 - 10% Yes
Sodium nitrate 7631-99-4 5 - 10% Yes
Nickel nitrate 13138-45-9 5 - 10% Yes
Phosphoric acid 7664-38-2 1 - 5% Yes

Concentration range is provided to assist users in providing appropriate protections.

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

Remove person immediately to fresh air.

Skin contact

Immediately flush with large quantities of water for at least 15 minutes. Remove contaminated clothing.

Eye contact

Rinse immediately with plenty of water for 15 minutes.

Ingestion

Do not induce vomiting. Give one to two glasses of water or milk. Never give anything by mouth to a victim who is unconscious or is having convulsions.

Immediate Medical Attention

Seek medical attention if symptoms develop or persist. GET MEDICAL ATTENTION. Seek immediate medical attention. Get immediate medical attention.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Water spray (fog), foam, dry chemical or carbon dioxide.

Unsuitable media

Not available.

Specific hazards

May liberate large quantities of dense, foul-smelling smoke which may contain unidentified toxic gasses.

Instructions

Wear full protective clothing. Wear self-contained breathing apparatus.

Firefighter Protection

Wear full protective clothing. Wear self-contained breathing apparatus.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel.

Environmental

Prevent further leakage or spillage if safe to do so.

Cleanup methods

Absorb spill with inert material. Shovel material into appropriate container for disposal.

Materials: inert material

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Avoid contact with eyes, skin and clothing. Wash thoroughly after handling. Avoid breathing vapors or mists of this product. Use caution when combining with water; DO NOT add water to acid, ALWAYS add acid to water while stirring to prevent release of heat, steam and fumes. Do not take internally. For industrial use only.

Storage

Keep container tightly closed and in a cool, well-ventilated place away from incompatible materials. Thaw and mix thoroughly if frozen.

Hygiene

Wash thoroughly after handling.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Physical State
Liquid
Physical State Data
liquid
State Under Standard Conditions
---
Appearance
---
Colour
Green
Colour Intensity
---
Form
---
Odor
Acidic
Odor Threshold
Not available.
Ph
2.6 (6% solution)
Melting Point
Not determined
Boiling Point
> 98.9 °C (> 210°F)
Flash Point
Not applicable
Freezing Point
---
Softening Point
---
Solidification Point
---
Cloud Point
---
Crystallisation Point
---
Relative Evaporation Rate
---
Evaporation Rate
Not determined
Vapor Pressure
Not determined
Vapor Density
---
Relative Density
1.42 - 1.46 at 60 °F (15.56 °C)
Bulk Density
---
Density
1.42 - 1.46 at 60 °F (15.56 °C)
Flammability
Not applicable
Upper Explosive Limit
Not applicable
Lower Explosive Limit
Not applicable
Explosive Limits
---
Auto Ignition Temperature
Not applicable
Decomposition Temperature
Not available.
Solubility
Complete
Partition Coefficient
Not determined
Solubility In Water
---
Solubility In Fat
---
Molecular Weight
---
Voc Content
Not applicable
Metal Corrosion
---
Dynamic Viscosity
Not available.
Kinematic Viscosity
Not available.
Properties Status
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable at normal conditions.

Reactivity

Not available.

Hazardous reactions

None under normal processing.

Avoid

Store away from incompatible materials.

Incompatible

This product may react with strong alkalies. Nitrites may react with organic amines to form nitrosamines which can cause cancer.

Decomposition

Decomposes with heat to produce oxides of nitrogen. Decomposition of this product may yield metallic oxides.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
1805
Shipping Name
Phosphoric acid solution
Transport Class
8
Packing Group
III
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP?

The signal word is danger.

What is the physical form of BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP?

BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP is a liquid with green color. It has acidic odor.

What is the solubility of BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP?

Complete

What is BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP used for?

Conversion coating

What are the hazard statements for BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP?

This substance has 8 hazard statements:

  • H272: MAY INTENSIFY FIRE; OXIDIZER.
  • H314: CAUSES SEVERE SKIN BURNS AND EYE DAMAGE.
  • H317: MAY CAUSE AN ALLERGIC SKIN REACTION.
  • H334: MAY CAUSE ALLERGY OR ASTHMA SYMPTOMS OR BREATHING DIFFICULTIES IF INHALED.
  • H341: SUSPECTED OF CAUSING GENETIC DEFECTS.
  • H350: MAY CAUSE CANCER.
  • H360: MAY DAMAGE FERTILITY OR THE UNBORN CHILD.
  • H372: CAUSES DAMAGE TO ORGANS THROUGH PROLONGED OR REPEATED EXPOSURE.

What is the melting point of BONDERITE M-ZN CD-10 MU ZINC PHOSPHATE known as BONDERITE CD-10 MAKEUP?

The melting point is Not determined and the boiling point is > 98.9 °C (> 210°F).