Surface Shield

Move to fresh air. Oxygen or artificial respiration if needed.

Wash contact areas with soap and water. Remove contaminated clothing. Launder contaminated clothing before reuse.

Symptoms: skin irritation or an allergic skin reaction

Flush thoroughly with water.

Do NOT induce vomiting. If vomiting occurs naturally, have victim lean forward to reduce risk of aspiration. Call a poison control center immediately.

Halon. Dry chemicals. Foam. Carbon dioxide (CO2). Water spray or fog.

Do not use water jet as an extinguisher, as this will spread the fire.

No unusual fire or explosion hazards noted.

Keep unauthorized people out and try to contain spills or leaks if it can be done safely. Material will float on water, avoid spreading the fire. Cool containers exposed to flames with water until well after the fire is out.

Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading.

Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth or absorbent material then place into containers. Following product recovery, flush area with water.

Prevent entry into waterways, sewer, basements or confined areas. Avoid discharge to the aquatic environment.

Absorb in vermiculite, dry sand or earth or absorbent material then place into containers. Following product recovery, flush area with water. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination.

Materials: vermiculite, dry sand or earth or absorbent material, cloth, fleece

FOR INDUSTRIAL USE ONLY. KEEP OUT OF REACH OF CHILDREN. Use in accordance with good work place practices. Use with adequate ventilation. Keep containers closed when not in use. Always open containers slowly to allow any excess pressure to vent. Avoid breathing vapor. Avoid contact with eyes, skin or clothing. Wash thoroughly with soap and water after handling. Decontaminate soiled clothing thoroughly before re-use. Destroy contaminated leather clothing. Do not breathe dust/fume/gas/mist/vapors/spray. Wash hands after handling and before eating. Do not get this material in contact with eyes. Avoid contact with skin. Avoid prolonged exposure. All handling to take place in well-ventilated area. Shower after work. Remove and wash contaminated clothing promptly. Empty containers may contain residues from the product. Treat empty containers with the same precautions as the material last contained. Do not cut, weld or apply heat to empty containers.

Store in a cool, dry area, away from heat or direct sunlight. Keep containers closed when not in use.

Wash thoroughly with soap and water after handling. Decontaminate soiled clothing thoroughly before re-use. Destroy contaminated leather clothing. Wash hands after handling and before eating. Shower after work. Remove and wash contaminated clothing promptly.

Do not cut, weld or apply heat to empty containers.

General or dilution ventilation is frequently insufficient as the sole means of controlling employee exposure. Local ventilation is usually preferred. Use a NIOSH approved respirator if ventilation is not adequate to maintain exposures below TLV levels.

Use synthetic gloves if necessary to prevent excessive skin contact.

Do not wear contacts and always use ANSI approved safety glasses or splash shield.

Based on workplace contaminant level and working limits of the respirator, use a respirator approved by NIOSH. The following is the minimum recommended equipment for an occupational exposure level. For concentrations > 1 and < 10 times the occupational exposure level: Use air-purifying respirator with full facepiece and organic vapor cartridge(s) or air-purifying full facepiece respirator with an organic vapor canister or a full facepiece powered air-purifying respirator fitted with organic vapor cartridge(s). The air purifying element must have an end of service life indicator, or a documented change out schedule must be established. Otherwise, use supplied air.

Stable

Will not occur

Heat, spark, and open flame

Strong Oxidizing Agents

Combustion will produce Carbon Monoxide, Carbon Dioxide and nitrogen-oxygen compounds.