PHOSPHORIC ACID >25 ...%

Remove affected person from source of contamination. Get medical attention if any discomfort continues.

Symptoms: Gas or vapour in high concentrations may irritate the respiratory system.

Remove contaminated clothing immediately and wash skin with soap and water. Get medical attention immediately.

Symptoms: May cause serious chemical burns to the skin.

Rinse immediately with plenty of water. Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes. Get medical attention immediately. Continue to rinse.

Symptoms: Causes serious eye damage. May cause permanent damage if eye is not immediately irrigated.

Rinse mouth thoroughly with water. Do not induce vomiting. If vomiting occurs, the head should be kept low so that stomach vomit doesn't enter the lungs. Give plenty of water to drink. Get medical attention immediately.

Symptoms: Harmful if swallowed. May cause chemical burns in mouth and throat.

Extinguish with alcohol-resistant foam, carbon dioxide, dry powder or water fog.

Do not use water jet as an extinguisher, as this will spread the fire.

In contact with some metals can generate hydrogen gas, which can form explosive mixtures with air.

Wear protective clothing as described in Section 8 of this safety data sheet. Avoid inhalation of spray mist and contact with skin and eyes.

Avoid discharge into water courses or onto the ground.

Neutralise spilled material with crushed limestone, slaked lime (calcium hydroxide), soda ash (sodium carbonate) or sodium bicarbonate. Absorb spillage with inert, damp, non-combustible material. Flush contaminated area with plenty of water. Collect and place in suitable waste disposal containers and seal securely.

Materials: crushed limestone, slaked lime (calcium hydroxide), soda ash (sodium carbonate), sodium bicarbonate, inert, damp, non-combustible material

Avoid spilling. Avoid inhalation of vapours and contact with skin and eyes.

Store in tightly-closed, original container in a dry, cool and well-ventilated place.

Provide adequate ventilation.

The most suitable glove should be chosen in consultation with the glove supplier/manufacturer, who can provide information about the breakthrough time of the glove material. The selected gloves should have a breakthrough time of at least 8 hours. Butyl rubber. Viton rubber (fluoro rubber). Nitrile rubber. Rubber (natural, latex). glove thickness 0.7mm The selected gloves should have a breakthrough time of at least 0.5 hours. Nitrile rubber. Rubber (natural, latex). Viton rubber (fluoro rubber). Butyl rubber. glove thickness 0.4mm To protect hands from chemicals, gloves should comply with European Standard EN374.

The following protection should be worn: Chemical splash goggles or face shield. EN 166

If ventilation is inadequate, suitable respiratory protection must be worn. EN 136/140/145/143/149

Wear suitable protective clothing as protection against splashing or contamination.

Stable at normal ambient temperatures and when used as recommended.

There are no known reactivity hazards associated with this product.

No information required.

Avoid excessive heat for prolonged periods of time.

Strong alkalis. Aluminium.

Thermal decomposition or combustion may liberate carbon oxides and other toxic gases or vapours.