INTERTHANE 990 RAL5010 GENTIAN BLUE PtA

Remove to fresh air, keep patient warm and at rest. If breathing is irregular or stopped, give artificial respiration. If unconscious place in the recovery position and obtain immediate medical attention. Give nothing by mouth.

Remove contaminated clothing. Wash skin thoroughly with soap and water or use a recognised skin cleanser. Do NOT use solvents or thinners.

Irrigate copiously with clean fresh water for at least 10 minutes, holding the eyelids apart and seek medical attention.

If accidentally swallowed obtain immediate medical attention. Keep at rest. Do NOT induce vomiting.

alcohol resistant foam, CO2, powder, water spray

water jet

Fire will produce dense black smoke. Decomposition products may be hazardous to health.

Cool closed containers exposed to fire by spraying them with water.

Remove sources of ignition, do not turn lights or unprotected electrical equipment on or off. In case of a major spill or spillage in a confined space evacuate the area and check that solvent vapour levels are below the Lower Explosive Limit before re-entering.

Do not allow spills to enter drains or watercourses.

Clean, preferably with a detergent. Do not use solvents.

This coating contains solvents. Solvent vapours are heavier than air and may spread along floors. Vapours may form explosive mixtures with air. Areas of storage, preparation and application should be ventilated to prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentrations higher than the occupational exposure limits.

Handle containers carefully to prevent damage and spillage. Naked flames and smoking should not be permitted in storage areas. It is recommended that fork lift trucks and electrical equipment are protected to the appropriate standard.

Smoking, eating and drinking should be prohibited in all preparation and application areas.

Naked flames and smoking should not be permitted in storage areas.

Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction.

Gloves of an appropriate material should be worn during mixing and application.

Wear safety eyewear, e.g. safety spectacles, goggles or visors to protect against the splash of liquids. Eyewear should comply with an approved standard. Wear a full face shield if mixing or pouring operations pose a risk of splashes.

If these are not sufficient to maintain concentrations of particulates and any vapour below occupational exposure limits suitable respiratory protection must be worn. When concentrations exceed the exposure limits shown above, workers must wear appropriate approved respirators. Provision of other controls such as exhaust ventilation should be considered if practical.

Overalls which cover the body, arms and legs should be worn. Skin should not be exposed. Barrier creams may help to protect areas which are difficult to cover such as the face and neck. They should however not be applied once exposure has occurred. Petroleum jelly based types such as Vaseline should not be used.

Stable under recommended storage and handling conditions (see section 7).

No data available

May react exothermically with: oxidising agents, strong alkalis, strong acids.

high temperatures

oxidising agents, strongly alkaline and strongly acid materials

carbon monoxide, carbon dioxide, oxides of nitrogen and smoke