1,2-Dibromoethane

Remove from exposure, lie down. Remove to fresh air. If not breathing, give artificial respiration.

Symptoms: Difficulty in breathing. Inhalation of high vapor concentrations may cause symptoms like headache, dizziness, tiredness, nausea and vomiting.

Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes.

Clean mouth with water.

Water spray. Carbon dioxide (CO₂). Dry chemical. Chemical foam.

No information available.

Thermal decomposition can lead to release of irritating gases and vapors.

Do not flush into surface water or sanitary sewer system.

Soak up with inert absorbent material

Materials: sand, silica gel, acid binder, universal binder, sawdust

Do not breathe mist/vapors/spray. Do not get in eyes, on skin, or on clothing.

Keep in a dry, cool and well-ventilated place. Keep container tightly closed. Protect from direct sunlight. Do not store in metal containers.

Handle in accordance with good industrial hygiene and safety practice. Keep away from food, drink and animal feeding stuffs. Do not eat, drink or smoke when using this product. Remove and wash contaminated clothing and gloves, including the inside, before re-use. Wash hands before breaks and after work.

Ensure adequate ventilation, especially in confined areas. Ensure that eyewash stations and safety showers are close to the workstation location. Wherever possible, engineering control measures such as the isolation or enclosure of the process, the introduction of process or equipment changes to minimise release or contact, and the use of properly designed ventilation systems, should be adopted to control hazardous materials at source

Protective gloves. Glove material: Viton (R). Breakthrough time: See manufacturers recommendations. EU standard: EN 374. Glove comments: (minimum requirement)

Goggles (European standard - EN 166)

When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. To protect the wearer, respiratory protective equipment must be the correct fit and be used and maintained properly. Large scale/emergency use: Use a NIOSH/MSHA or European Standard EN 136 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. Recommended Filter type: Organic gases and vapours filter Type A Brown conforming to EN14387. Small scale/Laboratory use: Use a NIOSH/MSHA or European Standard EN 149:2001 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced. Recommended half mask:- Valve filtering: EN405; or; Half mask: EN140; plus filter, EN 141. When RPE is used a face piece Fit Test should be conducted

Wear appropriate protective gloves and clothing to prevent skin exposure. Inspect gloves before use. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. (Refer to manufacturer/supplier for information) Ensure gloves are suitable for the task: Chemical compatibility, Dexterity, Operational conditions, User susceptibility, e.g. sensitisation effects, also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion. Remove gloves with care avoiding skin contamination.

Prevent product from entering drains. Do not allow material to contaminate ground water system.

Decomposes in contact with water, heat sensitive. Light sensitive. Decomposes on exposure to light.

None known, based on information available

No information available.

contact with water, heat, light

water

Carbon monoxide (CO). Carbon dioxide (CO₂). Hydrogen halides.