AMPERE TRAFFIC PAINT

In the event of massive inhalation, remove the person exposed to fresh air. Keep warm and at rest. If the person is unconscious, place in recovery position. If breathing is irregular or has stopped, effect mouth-to-mouth resuscitation and call a doctor.

Remove contaminated clothing and wash the skin thoroughly with soap and water or a recognised cleaner. Watch out for any remaining product between skin and clothing, watches, shoes, etc.

Symptoms: allergic reaction

Wash thoroughly with fresh, clean water for 15 minutes holding the eyelids open.

Symptoms: redness, pain or visual impairment

In the event of swallowing, if the quantity is small (no more than one mouthful), rinse the mouth with water and consult a doctor. Keep the person exposed at rest. Do not force vomiting. Seek medical attention, showing the label.

sprayed water or water mist - water with AFFF (Aqueous Film Forming Foam) additive, halon - foam, multipurpose ABC powder - BC powder - carbon dioxide (CO2)

water jet

pressurised containers from bursting

Keep packages near the fire cool, to prevent pressurised containers from bursting.

Eliminate sources of ignition and ventilate the area. Avoid inhaling the vapors. Avoid any contact with the skin and eyes. If a large quantity has been spilt, evacuate all personnel and only allow intervention by trained operators equipped with safety apparatus.

evacuate all personnel and only allow intervention by trained operators equipped with safety apparatus

Contain and control the leaks or spills with non-combustible absorbent materials such as sand, earth, vermiculite, diatomaceous earth in drums for waste disposal. Prevent any material from entering drains or waterways.

Clean preferably with a detergent, do not use solvents.

Always wash hands after handling. Remove and wash contaminated clothing before re-using. Avoid skin and eye contact with this mixture.

Keep packages tightly closed and away from sources of heat, sparks and naked flames. Packages which have been opened must be reclosed carefully and stored in an upright position.

Always wash hands after handling. Remove and wash contaminated clothing before re-using. No smoking, eating or drinking in areas where the mixture is used.

Do not spray on a naked flame or any incandescent material. Do not pierce or burn, even after use. Use the mixture in premises free of naked flames or other sources of ignition and ensure that electrical equipment is suitably protected. Keep packages tightly closed and away from sources of heat, sparks and naked flames. Do not use tools which may produce sparks. Do not smoke.

Ensure that there is adequate ventilation, especially in confined areas.

Use suitable protective gloves that are resistant to chemical agents in accordance with standard EN ISO 374-1. Gloves must be selected according to the application and duration of use at the workstation. Protective gloves need to be selected according to their suitability for the workstation in question : other chemical products that may be handled, necessary physical protections (cutting, pricking, heat protection), level of dexterity required. Type of gloves recommended : Nitrile rubber (butadiene-acrylonitrile copolymer rubber (NBR)), PVA (Polyvinyl alcohol)

Avoid contact with eyes. Use eye protectors designed to protect against liquid splashes. Before handling, wear safety goggles with protective sides accordance with standard EN166. In the event of high danger, protect the face with a face shield. Prescription glasses are not considered as protection. Individuals wearing contact lenses should wear prescription glasses during work where they may be exposed to irritant vapours.

Avoid inhaling vapors. If the ventilation is insufficient, wear appropriate breathing apparatus. When workers are confronted with concentrations that are above occupational exposure limits, they must wear a suitable, approved, respiratory protection device. Type of FFP mask : Wear a disposable half-mask aerosol filter in accordance with standard EN149/A1. Category : FFP1 Anti-gas and vapour filter(s) (Combined filters) in accordance with standard EN14387 : - A1 (Brown). Particle filter according to standard EN143 : - P1 (White)

Avoid skin contact. Wear suitable protective clothing. Suitable type of protective clothing : In the event of substantial spatter, wear liquid-tight protective clothing against chemical risks (type 3) in accordance with EN14605/A1 to prevent skin contact. In the event of a risk of splashing, wear protective clothing against chemical risks (type 6) in accordance with EN13034/A1 to prevent skin contact. Work clothing worn by personnel shall be laundered regularly.

This mixture is stable under the recommended handling and storage conditions in section 7.

No data available.

When exposed to high temperatures, the mixture can release hazardous decomposition products, such as carbon monoxide and dioxide, fumes and nitrogen oxide.

high temperatures

No data available.

carbon monoxide and dioxide, fumes and nitrogen oxide

SW1 SW22