1,2,4-Trichlorobenzene

After inhalation: fresh air.

In case of skin contact: Take off immediately all contaminated clothing. Rinse skin with water/ shower.

After eye contact: rinse out with plenty of water. Remove contact lenses.

After swallowing: immediately make victim drink water (two glasses at most). Consult a physician.

Water, Foam, Carbon dioxide (CO2), Dry powder

For this substance/mixture no limitations of extinguishing agents are given.

Combustible. Vapours are heavier than air and may spread along floors. Forms explosive mixtures with air on intense heating. Development of hazardous combustion gases or vapours possible in the event of fire.

Suppress (knock down) gases/vapours/mists with a water spray jet.

Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains.

Take up with liquid-absorbent material (e.g. Chemizorb®). Dispose of properly. Clean up affected area.

Materials: liquid-absorbent material (e.g. Chemizorb®)

Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance. For precautions see section 2.2.

Tightly closed. Keep in a well-ventilated place. Keep locked up or in an area accessible only to qualified or authorised persons.

Immediately change contaminated clothing. Apply preventive skin protection. Wash hands and face after working with substance.

Material : Viton®; Break through time : 480 min; Glove thickness : 0,7 mm; Protective index : Full contact; Manufacturer : Vitoject® (KCL 890 / Aldrich Z677698, Size M). Material : Nitrile rubber; Break through time : 10 min; Glove thickness : 0,4 mm; Protective index : Splash contact; Manufacturer : Camatril® (KCL 730 / Aldrich Z677442, Size M). Remarks : This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN 16523-1 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses

required when vapours/aerosols are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter type: Filter A (acc. to DIN 3181) for vapours of organic compounds. The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

protective clothing

Do not let product enter drains.

The product is chemically stable under standard ambient conditions (room temperature).

Forms explosive mixtures with air on intense heating. A range from approx. 15 Kelvin below the flash point is to be rated as critical.

Exothermic reaction with: Oxidizing agents, Alkali metals, Alkaline earth metals. Risk of explosion with: fire-promoting substances

Strong heating.

No data available

In the event of fire: see section 5