CoverPlus

Leave the contaminated area – breathe in fresh air. If symptoms occur and persist, seek medical advice.

Symptoms: Overexposure to haze or vapours may cause respiratory irritation.

Remove the contaminated clothes and footwear. Parts of the body that come into contact with the preparation should be rinsed with plenty of running water. If symptoms occur and persist, seek medical advice. Remove contaminated clothing and shoes before reuse.

Symptoms: Skin contact can trigger an allergic response (symptoms: itch, skin redness, rash). May cause irritation (redness, itch) when in contact with skin.

Eyes should be open, also under eyelids, rinse immediately with plenty of running water. If symptoms occur and persist, seek medical advice.

Symptoms: Can cause reddening, pain or tearing when in contact with eyes.

Do not give anything into the mouth of an unconscious person. Do not induce vomiting! Seek medical attention immediately! Show the Safety Data Sheet or label to the doctor.

Symptoms: Can cause nausea/vomiting and diarrhoea. It can cause abdominal pain.

Carbon dioxide CO₂, extinguishing powder, dispersed water jet, alcohol-resistant foam. Choose fire extinguishing agents according to the current conditions.

Direct water jet.

In case of fire, toxic gasses may be generated; prevent inhalation of gases/fumes.

In the event of a fire, immediately confine the area and evacuate all persons in the vicinity. In case of fire and/or heating, do not breathe fumes/gases. Do not intervene if you risk your health and if you are not properly trained. Cool the exposed packaging with dispersed water jet. Remove undamaged containers from the hazardous area if it can be done safely.

Do not intervene if you risk your health and if you are not properly trained. Prevent access by unprotected persons. Evacuate the danger zone. Do not inhale vapour/mist. Avoid contact with skin, eyes, and clothing. Slip hazard due to a scattered/spilled product.

Prevent leakage into waters, drains, sewage system or on impervious soil with appropriate dams. In case of larger water release or on pervious soil, call the emergency number (112).

Absorb the product with an inert material (absorbent, sand), collect it in special containers and leave them to the authorised waste undertaker for handling.

Materials: inert material (absorbent, sand)

Ensure good ventilation. Provide local extraction (ventilation) where there is possibility of inhalation of vapours and aerosols. Do not discharge into the sewage system, surface water, or ground. Close the packaging tightly immediately after use. Comply with the measures prescribed in section 8 of this SDS. Take care of personal hygiene (washing hands before break and after work). Do not eat, drink and smoke during work. Do not inhale vapour/mist. Avoid contact with skin, eyes, and clothing. Take off contaminated clothing and wash it before reuse. Ensure tidiness and cleanliness. Follow the instructions on the label and the regulations on safety and health at work.

Store in a cool, dry, and well-ventilated place. Keep in well closed rooms. Store away from food, drink, and animal food.

Take care of personal hygiene (washing hands before break and after work). Do not eat, drink and smoke during work. Do not inhale vapour/mist. Avoid contact with skin, eyes, and clothing. Take off contaminated clothing and wash it before reuse. Ensure tidiness and cleanliness.

Ensure good ventilation.

Provide for good ventilation and local suction in areas with higher concentration.

Protective gloves (SIST EN ISO 374-1:2017/A1:2018). Use only category III protective gloves with the CE marking (SIST EN ISO 374-1:2017/A1:2018). The product is a mixture of different substances so the durability of the gloves cannot be determined in advance and must be checked before use. Follow the manufacturer's instructions for use, storage, maintenance, and replacement of gloves. When damage or first signs of wear occur, the gloves should be replaced immediately. Choosing the right gloves depends not only on the material, but also on other quality criteria that vary from manufacturer to manufacturer. The penetration time is set by the glove manufacturer and must be observed.

If there is a risk of contact with eyes, wear protective goggles. Safety goggles with lateral protection (SIST EN ISO 16321-1:2022).

Not necessary in case of normal use and with adequate ventilation. In the case of elevated concentrations of vapours/aerosols in the air, use a half-face mask (SIST EN 140:1999/AC:2000) with a combined A2-P2 filter (SIST EN 14387:2021). Elevated concentrations mean that the occupational exposure limit values are exceeded. When selecting the suitable respiratory protection, take under consideration the type of the applied chemicals, work conditions, method of application of the equipment, and the condition of the protection equipment.

Protective cotton working clothes and footwear that covers the entire foot (SIST EN ISO 20345:2022). Protective clothing resistant against liquid chemical substances (SIST EN 14605:2005+A1:2009). Body protection should be chosen according to the activity and possible exposure.

Avoid discharge into watercourses, sewers, or groundwater.

Stable under normal use. Stable under recommended transport and storage conditions.

The product is non-reactive.

No information.

Mixing with acids is not recommended.

acids

No hazardous decomposition products are expected with normal use. Gases discharge upon burning/explosion, which are harmful to health.

Disposal in accordance with the Rules on the management of waste. Reuse or recycle if possible. Leave to an authorised collector/disposer/processor of hazardous waste.

Disposal in accordance with the Rules on the management of waste. Reuse or recycle if possible. Leave to an authorised collector/disposer/processor of hazardous waste.

Limited quantities