INTERTHANE 990 PART B

If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention immediately.

Symptoms: Harmful if inhaled. May cause lung injury. May cause mucous membrane and respiratory tract irritation, tightness of chest, headache, shortness of breath and dry cough. May cause asthma-like symptoms to occur. Vapors may affect the brain or nervous system causing dizziness, headache or nausea.

In case of contact, immediately flush skin with soap and plenty of water. Get medical attention immediately.

Symptoms: Causes skin irritation. May be harmful if absorbed through the skin.

In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention immediately.

Symptoms: Causes severe eye irritation.

If swallowed, immediately contact Poison Control Center at 1-800-854-6813. Never give anything by mouth to an unconscious person.

Symptoms: Harmful if swallowed. May cause abdominal pain, nausea, vomiting, diarrhea, or drowsiness.

SMALL FIRES: Use dry chemical, CO2, water spray or regular foam. LARGE FIRES: Use water spray, fog, or regular foam. For mixtures containing alcohol or polar solvent, alcohol-resistant foam may be more effective.

Do not use straight streams. Use of water spray when fighting fire may be inefficient.

This product has a very low flashpoint.

Move containers from fire area if you can do so without risk.

Stop leak if you can do so without risk. Do not touch or walk through spilled material.

Consider initial downwind evacuation for at least 300 meters (1000 feet).

Prevent entry into waterways, sewers, basements or confined areas.

Absorb or cover with dry earth, sand, or other non-combustible material and transfer to containers. Use non-sparking tools to collect absorbed material.

Materials: dry earth, sand, or other non-combustible material

Vapors may cause flash fire or ignite explosively.

Keep away from heat, sparks and flame.

Wash thoroughly after handling.

Keep away from heat, sparks and flame.

Depending on the site-specific conditions of use, provide adequate ventilation.

Avoid contact with eyes. Protective equipment should be selected to provide protection from exposure to the chemicals listed in Section 3 of this document. Depending on the site-specific conditions of use, safety glasses, chemical goggles, and/or head and face protection may be required to prevent contact. The equipment must be thoroughly cleaned, or discarded after each use.

Select equipment to provide protection from the ingredients listed in Section 3 of this document. Ensure fresh air entry during application and drying. If you experience eye watering, headache or dizziness or if air monitoring demonstrates dust, vapor, or mist levels are above applicable limits, wear an appropriate, properly fitted respirator (NIOSH approved) during and after application. Follow respirator manufacturer's directions for respirator use. FOR USERS OF 3M RESPIRATORY PROTECTION ONLY: For information and assistance on 3M occupational health and safety products, call OH&ESD Technical Service toll free in U.S.A. 1-800-243-4630, in Canada call 1-800-267-4414. Please do not contact these numbers regarding other manufacturer's respiratory protection products. 3M does not endorse the accuracy of the information contained in this Material Safety Data Sheet. INDIVIDUALS WITH LUNG OR BREATHING PROBLEMS OR PRIOR REACTION TO ISOCYANATES MUST NOT BE EXPOSED TO VAPOR OR SPRAY MIST. Do not breathe vapor or spray mist. Wear an appropriate, properly fitted respirator (NIOSH approved) during and after application unless air monitoring demonstrates vapor/mist levels are below applicable limits. A supplied air respirator (either positive pressure or continuous flow type) is required. Follow manufacturer's directions for respirator use and observe requirements specified in 29 CFR 1910.134.

Protective equipment should be selected to provide protection from exposure to the chemicals listed in Section 3 of this document. Depending on the site-specific conditions of use, protective gloves, apron, boots, head and face protection may be required to prevent contact. The equipment must be thoroughly cleaned, or discarded after each use.

This product is stable

No data available

hazardous polymerization will not occur

Excessive heat

Strong oxidizing agents.

fumes

Dispose of in accordance with local, state and federal regulations.

Dispose of in accordance with local, state and federal regulations.