Upholstery & Interior Cleaner

Upon breathing difficulties or irritation of the respiratory tract: Bring the person into fresh air and stay with him/her.

Symptoms: breathing difficulties or irritation of the respiratory tract

Remove contaminated clothing and shoes immediately. Ensure to wash exposed skin thoroughly with water and soap. Skin cleanser can be used. DO NOT use solvents or thinners.

If in eyes: Flush eyes with water or saline water (20-30 °C) for at least 5 minutes. Remove contact lenses. Seek medical assistance and continue flushing during transport.

If the person is conscious, rinse the mouth with water and stay with the person. Never give the person anything to drink. In case of malaise, seek medical advice immediately and bring the safety data sheet or label from the product. Do not induce vomiting, unless recommended by the doctor. Have the person lean forward with head down to avoid inhalation of or choking on vomited material.

Symptoms: malaise

Not applicable.

Fire will result in dense smoke. Exposure to combustion products may harm your health.

Closed containers, which are exposed to fire, should be cooled with water.

Ensure adequate ventilation, especially in confined areas. Contaminated areas may be slippery.

Avoid discharge to lakes, streams, sewers, etc. In the event of leakage to the surroundings, contact local environmental authorities.

cleaning should be performed with normal cleaning agents. Avoid use of solvents.

Smoking, drinking and consumption of food is not allowed in the work area.

5 - 30°C

Smoking, drinking and consumption of food is not allowed in the work area.

The formation of vapours must be kept at a minimum and below current limit values (see above). Installation of a local exhaust system if normal air flow in the work room is not sufficient is recommended. Ensure eyewash and emergency showers are clearly marked.

Material: Nitrile, Glove thickness: 0,2 mm, Breakthrough time: >120 min, Standards: EN374-2, EN16523-1, EN388. Chemical-resistant, impervious gloves complying with an approved standard should be worn if a risk assessment indicates skin contact is possible. Gloves made from the following material may provide suitable chemical protection: Nitrile rubber. Thickness: > 0.2 mm. The selected gloves should have a breakthrough time of at least 2 hours.

Safety glasses with side shields. EN ISO 16321-1. Eyewear complying with an approved standard should be worn if a risk assessment indicates eye contact is possible. Personal protective equipment that provides appropriate eye and face protection should be worn. Wear tight-fitting, chemical splash goggles or face shield.

Respiratory protection complying with an approved standard should be worn if a risk assessment indicates inhalation of contaminants is possible. Ensure all respiratory protective equipment is suitable for its intended use and is appropriately marked to a relevant standard. Check that the respirator fits tightly and the filter is changed regularly. Gas and combination filter cartridges suitable for intended use, Full face mask respirators with replaceable filter cartridges suitable for intended use, half mask and quarter mask respirators with replaceable filter cartridges suitable for intended use, can all be used.

Appropriate footwear and additional protective clothing complying with an approved standard should be worn if a risk assessment indicates skin contamination is possible.

Keep damning materials near the workplace. If possible, collect spillage during work.

The product is stable under the conditions, noted in section 7 "Handling and storage".

No data available.

None known.

None known.

Strong acids, strong bases, strong oxidizing agents, and strong reducing agents.

Under normal conditions of storage and use, hazardous decomposition products should not be produced.

Dispose of contents/container to an approved waste disposal plant.