Sodium Sulfite anhydrous photo, non food grade

If difficulties occur after dust has been inhaled, remove to fresh air and seek medical attention. After inhalation of decomposition products: Immediately administer a corticosteroid from a controlled/metered dose inhaler. Seek medical attention.

Symptoms: bronchoconstriction

Wash thoroughly with soap and water

Symptoms: dermatitis, urticaria, angio-oedema

Immediately wash affected eyes for at least 15 minutes under running water with eyelids held open, consult an eye specialist.

Immediately rinse mouth and then drink 200-300 ml of water, seek medical attention.

Symptoms: abdominal pain, diarrhoea, anaphylaxis

water spray, carbon dioxide, foam, dry powder. Use extinguishing measures to suit surroundings.

Endangering substances: sulphur dioxide. The substances/groups of substances mentioned can be released if the product is involved in a fire.

Product itself is non-combustible; fire extinguishing method of surrounding areas must be considered.

Avoid contact with the skin, eyes and clothing.

Do not discharge into drains/surface waters/groundwater. Do not discharge into the subsoil/soil. Retain and dispose of contaminated wash water.

Sweep/shovel up.

Use only in well-ventilated areas. Avoid dust formation. Avoid contact with skin and eyes.

Keep away from heat. Keep container tightly closed in a cool, well-ventilated place. Keep container dry. The product consumes oxygen. Danger of lack of oxygen in containers and tanks.

Avoid contact with skin and eyes.

The substance/product is non-combustible. No special precautions necessary.

Chemical resistant protective gloves (EN ISO 374-1) Suitable materials also with prolonged, direct contact (Recommended: Protective index 6, corresponding > 480 minutes of permeation time according to EN ISO 374-1): e.g. nitrile rubber (0.4 mm), chloroprene rubber (0.5 mm), polyvinylchloride (0.7 mm) and other Supplementary note: The specifications are based on tests, literature data and information of glove manufacturers or are derived from similar substances by analogy. Due to many conditions (e.g. temperature) it must be considered, that the practical usage of a chemical-protective glove in practice may be much shorter than the permeation time determined through testing. Manufacturer's directions for use should be observed because of great diversity of types.

Safety glasses with side-shields (frame goggles) (e.g. EN 166)

Breathing protection if dusts are formed. Suitable respiratory protection for lower concentrations or short-term effect: Particle filter with low efficiency for solid particles (e.g. EN 143 or 149, Type P1 or FFP1) Breathing protection if gases/vapours are formed. Combination filter for gases/vapours of organic, inorganic, acid inorganic, alkaline compounds and toxic particles (e.g. EN 14387 Type ABEK-P3)

Body protection must be chosen depending on activity and possible exposure, e.g. apron, protecting boots, chemical-protection suit (according to EN 14605 in case of splashes or EN ISO 13982 in case of dust).

The product is stable if stored and handled as prescribed/indicated.

No hazardous reactions if stored and handled as prescribed/indicated.

Reacts with nitrites. Reacts with nitrates. Reacts with oxidizing agents. Generation of sulphur dioxide upon exposure to acids. (or conditions.) The product consumes oxygen.

Avoid humidity. avoid atmospheric oxygen

nitrites, nitrates, oxidizing agents, acids

sulphur dioxide