3M Scotch-Weld™ Structural Adhesive EC-9323 B/A (Part A)

Remove person to fresh air.

Immediately flush with large amounts of water for at least 15 minutes. Remove contaminated clothing. Wash clothing before reuse.

Immediately flush with large amounts of water for at least 15 minutes. Remove contact lenses if easy to do. Continue rinsing.

Rinse mouth.

Use a fire fighting agent suitable for the surrounding fire.

None inherent in this product.

No special protective actions for fire-fighters are anticipated.

Evacuate area.

Avoid release to the environment.

Sweep up. Clean up residue.

Materials: closed container approved for transportation by appropriate authorities

Avoid breathing of dust created by cutting, sanding, grinding or machining. Do not breathe dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Wash contaminated clothing before reuse.

Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Store away from heat.

Do not eat, drink or smoke when using this product. Wash thoroughly after handling. Wash contaminated clothing before reuse.

Store away from heat.

Curing enclosures must be exhausted to outdoors or to a suitable emission control device. Provide appropriate local exhaust ventilation for cutting, grinding, sanding or machining. Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.

Gloves made from the following material(s) are recommended: Fluoroelastomer, Nitrile rubber. Use gloves tested to EN 374

Full face shield. Indirect vented goggles. Use eye/face protection conforming to EN 166

Wear respiratory protection if ventilation is inadequate to prevent overexposure. An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator type(s) to reduce inhalation exposure: Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates. Use a respirator conforming to EN 140 or EN 136: filter types A & P

If this product is used in a manner that presents a higher potential for exposure (eg. spraying, high splash potential etc.), then use of protective coveralls may be necessary. Select and use body protection to prevent contact based on the results of an exposure assessment. The following protective clothing material(s) are recommended: Apron – Nitrile

Refer to Annex

Stable.

This material may be reactive with certain agents under certain conditions - see the remaining headings in this section

Hazardous polymerisation will not occur.

Avoid curing large quantities of material to prevent a premature reaction (exotherm) with production of intense heat and smoke. Heat. Sparks and/or flames.

Strong oxidising agents.

None known. Refer to section 5.2 for hazardous decomposition products during combustion.

Dispose of completely cured (or polymerized) material in a permitted industrial waste facility. As a disposal alternative, incinerate uncured product in a permitted waste incineration facility.

Dispose of completely cured (or polymerized) material in a permitted industrial waste facility. As a disposal alternative, incinerate uncured product in a permitted waste incineration facility.