BrewerBOND® C1301-50

Remove victim to fresh air. Give artificial respiration if needed. If breathing is difficult, oxygen should be administered by qualified personnel. Get medical attention if irritation persists.

Symptoms: Moderate respiratory tract irritation. Inhalation of mists or vapors may cause headache, dizziness, nausea, and other symptoms of central nervous system depression.

Remove contaminated clothing. Wash contact area thoroughly with soap and water for several minutes. Get medical attention if irritation occurs. Launder clothing before re-use.

Symptoms: Moderate skin irritation.

Flush eyes thoroughly with water for several minutes, while holding the eyelids apart. Remove contact lenses if easy to do so. Continue rinsing. Get medical attention if irritation persists.

Symptoms: Moderate eye irritation.

Aspiration hazard: do NOT induce vomiting. Keep the victim calm and warm. If conscious, rinse mouth with water. Never give anything by mouth to an unconscious or convulsing person. If vomiting occurs spontaneously, keep head below hips to prevent aspiration into the lungs. Get immediate medical attention.

Symptoms: Aspiration hazard: material may enter the lungs if swallowed and cause lung injury.

Use water fog or spray, alcohol- resistant foam, carbon dioxide or dry chemical.

Vapors are heavier than air and may travel along surfaces to remote ignition sources and flash back. Vapors may form explosive mixtures with air in confined areas. As with any ether, 2-(1-Methoxy)propyl acetate (PGMEA) may form highly reactive peroxides upon contact with air.

Cool fire exposed containers with water.

Remove all ignition sources such as open flames, spark producing equipment, pilot lights, etc. Wear appropriate protective clothing to prevent eye and skin contact including impervious gloves, safety goggles and respirator if needed. Ventilate area.

Avoid releases to the environment.

collect into an appropriate container for disposal

Avoid breathing vapors, aerosols, and mists. Use with adequate ventilation. Avoid contact with the eyes, skin, and clothing. Always wear impervious gloves, chemical safety goggles and protective clothing when handling this material. Wash thoroughly after handling. Do not eat, drink, or smoke in the work area.

Keep containers closed when not in use.

Wash thoroughly after handling. Do not eat, drink, or smoke in the work area.

Keep product away from heat, sparks, flames, and all other sources of ignition. No smoking in storage or use areas.

Use with adequate general or local exhaust ventilation to maintain exposure levels below the occupational exposure limits. Use explosion proof electrical equipment and wiring where required.

Impervious gloves are recommended to prevent skin contact. Contact your glove supplier for selection assistance. In Europe follow EN 374.

Chemical safety goggles are recommended to avoid eye contact. In Europe follow EN 166.

If needed, an approved respirator with organic vapor cartridges may be used. For higher exposures, a supplied air respirator may be required. Respirator selection and use should be based on contaminant type, form and concentration. Follow applicable regulations and good Industrial Hygiene practice.

Impervious clothing is required to prevent skin contact and contamination of personal clothing. In Europe follow EN 13034.

Technical Onsite Conditions and Measures to Reduce or Limit Discharges, Air Emissions and Releases to Soil: Treat air emission to provide a typical removal efficiency of 98% PGMEA. Organization Measures to Prevent/Limit Release from Site: Site should have a spill plan to ensure that adequate safeguards are in place to minimize the impact of episodic releases. Use vapor recovery units when necessary. Conditions and Measures Related to Sewage Treatment Plant: Estimated substance removal from wastewater via domestic sewage treatment –87.3% PGMEA.

Stable under normal storage and handling conditions.

Not reactive

Hazardous polymerization will not occur.

Keep away from heat, sparks, flames, and other sources of ignition.

nitric acid

Thermal decomposition will produce oxides of carbon and unknown materials.

Dispose in accordance with all local, state, and federal regulations.