Industrial Gear Oil

First aid is not normally required. If breathing difficulties develop, move victim away from source of exposure and into fresh air in a position comfortable for breathing. Seek immediate medical attention.

Symptoms: breathing difficulties, respiratory irritation (from oil mists or vapors generated at elevated temperatures)

Remove contaminated shoes and clothing and cleanse affected area(s) thoroughly by washing with mild soap and water or a waterless hand cleaner. If irritation or redness develops and persists, seek medical attention.

Symptoms: irritation, redness, dry skin

If irritation or redness develops from exposure, flush eyes with clean water. If symptoms persist, seek medical attention.

Symptoms: irritation, redness

First aid is not normally required; however, if swallowed and symptoms develop, seek medical attention.

Symptoms: minor irritation of the digestive tract, nausea, diarrhea

Dry chemical, carbon dioxide, foam, or water spray is recommended.

Water or foam may cause frothing of materials heated above 212°F / 100°C. Carbon dioxide can displace oxygen. Use caution when applying carbon dioxide in confined spaces. Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam.

This material may burn, but will not ignite readily. If container is not properly cooled, it can rupture in the heat of a fire.

For fires beyond the initial stage, emergency responders in the immediate hazard area should wear protective clothing. Isolate the hazard area and deny entry to unnecessary and unprotected personnel. Stop spill/release if it can be done safely. Move undamaged containers from immediate hazard area if it can be done safely. Water spray may be useful in minimizing or dispersing vapors and to protect personnel. Cool equipment exposed to fire with water, if it can be done safely. Avoid spreading burning liquid with water used for cooling purposes.

Keep all sources of ignition away from spill/release. Stay upwind and away from spill/release. Avoid direct contact with material. For large spillages, notify persons down wind of the spill/release, isolate immediate hazard area and keep unauthorized personnel out.

notify persons down wind of the spill/release, isolate immediate hazard area and keep unauthorized personnel out.

Stop and contain spill/release if it can be done safely. Prevent spilled material from entering sewers, storm drains, other unauthorized drainage systems, and natural waterways. Use water sparingly to minimize environmental contamination and reduce disposal requirements.

Immediate cleanup of any spill is recommended. Dike far ahead of spill for later recovery or disposal. Absorb spill with inert material such as sand or vermiculite, and place in suitable container for disposal.

Materials: inert material such as sand or vermiculite

Keep away from flames and hot surfaces. Wash thoroughly after handling. Use good personal hygiene practices and wear appropriate personal protective equipment (see section 8). Spills will produce very slippery surfaces. Do not enter confined spaces such as tanks or pits without following proper entry procedures such as ASTM D-4276 and 29CFR 1910.146. Do not wear contaminated clothing or shoes.

Keep container(s) tightly closed and properly labeled. Use and store this material in cool, dry, well-ventilated area away from heat and all sources of ignition. Store only in approved containers. Keep away from any incompatible material (see Section 10). Protect container(s) against physical damage.

Wash thoroughly after handling. Use good personal hygiene practices. Do not wear contaminated clothing or shoes.

Keep away from flames and hot surfaces. Use and store this material in cool, dry, well-ventilated area away from heat and all sources of ignition.

Stable under normal ambient and anticipated conditions of use.

Not chemically reactive.

Hazardous reactions not anticipated.

Extended exposure to high temperatures can cause decomposition. Avoid all possible sources of ignition.

Avoid contact with strong oxidizing agents and strong reducing agents.

Not anticipated under normal conditions of use.

Whenever possible, Recycle used oil in accordance with applicable federal and state or local regulations.