Di(propylene glycol) methyl ether, mixture of isomers

If breathed in, move person into fresh air. If not breathing, give artificial respiration. Consult a physician.

Wash off with soap and plenty of water. Consult a physician.

Flush eyes with water as a precaution.

Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Rinse mouth with water. Consult a physician.

Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.

Avoid breathing vapours, mist or gas. Beware of vapours accumulating to form explosive concentrations. Vapours can accumulate in low areas.

Prevent further leakage or spillage if safe to do so.

collect with an electrically protected vacuum cleaner or by wet-brushing

Materials: suitable, closed containers

Avoid inhalation of vapour or mist. Keep away from sources of ignition - No smoking. Take measures to prevent the build up of electrostatic charge.

Keep container tightly closed in a dry and well-ventilated place.

Keep away from sources of ignition - No smoking. Take measures to prevent the build up of electrostatic charge.

Handle in accordance with good industrial hygiene and safety practice.

Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique (without touching glove's outer surface) to avoid skin contact with this product. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Wash and dry hands. Full contact: Material: Nitrile rubber, Minimum layer thickness: 0.4 mm, Break through time: 480 min, Material tested: Camatril® (KCL 730 / Aldrich Z677442, Size M). Splash contact: Material: Nitrile rubber, Minimum layer thickness: 0.11 mm, Break through time: 30 min, Material tested: Dermatril® (KCL 740 / Aldrich Z677272, Size M). Standards: EN374.

Safety glasses with side-shields conforming to EN166 Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).

Where risk assessment shows air-purifying respirators are appropriate use a full-face respirator with multi-purpose combination (US) or type ABEK (EN 14387) respirator cartridges as a backup to engineering controls. If the respirator is the sole means of protection, use a full-face supplied air respirator. Use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU).

Impervious clothing, The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace.

Prevent further leakage or spillage if safe to do so. Do not let product enter drains.

Stable under recommended storage conditions.

No data available

No data available

Heat, flames and sparks.

Strong oxidizing agents, Strong acids

Hazardous decomposition products formed under fire conditions. - Carbon oxides Other decomposition products - No data available In the event of fire: see section 5

This combustible material may be burned in a chemical incinerator equipped with an afterburner and scrubber.

Offer surplus and non-recyclable solutions to a licensed disposal company.