AESCULAP STERILIT I OILSPRAY

Move to fresh air in case of accidental inhalation of vapours.

Symptoms: Inhalation of high vapour concentrations may cause symptoms like headache, dizziness, tiredness, nausea and vomiting. Inhalation of vapours in high concentration can cause narcotic effects.

Wash off immediately with soap and plenty of water.

Symptoms: May cause eye/skin irritation. Rapid evaporation of the liquid may cause frostbite.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes.

Symptoms: May cause eye/skin irritation. Rapid evaporation of the liquid may cause frostbite.

Do not induce vomiting. Summon a doctor immediately. Induce vomiting only upon the advice of a physician.

Symptoms: Attention. Beware, danger of aspiration.

Foam, carbon dioxide (CO2), dry chemical, water-spray.

Full water jet

Fire may produce: Carbon monoxide and carbon dioxide. Heating will cause pressure rise with risk of bursting. Vapours are heavier than air and spread along ground. The vapour/air mixture is explosive, even in empty, uncleaned receptacles.

Cool containers at risk with water spray jet.

Ensure adequate ventilation. Use only explosion-proof equipment. Remove all sources of ignition. Avoid contact with skin, eyes and clothing.

Do not discharge into the drains/surface waters/groundwater. Do not discharge into the subsoil/soil.

Soak up with inert absorbent material. Shovel into suitable container for disposal.

Ensure adequate ventilation. Avoid contact with skin, eyes and clothing. Do not breathe aerosol.

Keep containers tightly closed in a cool, well-ventilated place. Keep away from food, drink and animal feeding stuffs.

Keep away from sources of ignition - No smoking.

Ensure adequate ventilation, especially in confined areas.

Protective gloves resistant to chemicals made of nitrile, Minimum coat thickness 0.4 mm, Permeation resistance (wear duration) approx. 120 minutes, i.e. protective glove <Camatril Velours 730> made by www.kcl.de. This recommendation refers exclusively to the chemical compatibility and the lab test conforming to EN 374 carried out under lab conditions. Requirements can vary as a function of the use. Therefore it is necessary to adhere additionally to the recommendations given by the manufacturer of protective gloves.

Safety goggles with side protection

In case of insufficient ventilation wear suitable respiratory equipment (gas filter type AX).

Long sleeved clothing.

Fire or intense heat may cause violent rupture of packages.

Strong oxidizing agents.

Carbon monoxide and carbon dioxide.

Can be incinerated, when in compliance with local regulations.

Where possible recycling is preferred to disposal.