NextSDS Logo
Safety Data Sheet EN

Vibra-TITE® Threadlocker

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
Vibra-TITE® Threadlocker
Product Code
VT131
Synonyms
131 Permanent Strength Threadlocker

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Thread Locking

Manufacturers & Suppliers

ND Industries, Inc logo

ND Industries, Inc

manufacturer

1000 North Crooks Road, Clawson, MI 48017, USA

+1-248-288-0000

http://www.ndindustries.com

Emergency Contacts

United States

1-800-424-9300

International

+1-703-527-3887

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified warning

Hazard Classifications

Carc. Cat. 2 H351
Skin Irrit. Cat. 2 H315
Eye Irrit. Cat. 2A H319
Skin Sens. Cat. 1 H317
STOT SE Cat. 3 H335

GHS Pictograms

GHS07 - Health hazard

GHS07

GHS08 - Serious health hazard

GHS08

Hazard Statements

H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H335 May cause respiratory irritation.
H351 Suspected of causing cancer.

Precautionary Statements

P201 Obtain special instructions before use.
P202 Do not handle until all safety precautions have been read and understood.
P261 Avoid breathing dust/fume/gas/mist/vapors/spray
P264 Wash face, hands and any exposed skin thoroughly after handling.
P271 Use only outdoors or in a well-ventilated area.
P272 Contaminated work clothing must not be allowed out of the workplace.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P280 Wear protective gloves.
P280 Wear eye protection / face protection.
P304+P340 IF INHALED: Remove person to fresh air and keep comfortable for breathing.
P305+P351+P338 If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present Continue rinsing.
P308+P313 IF exposed or concerned: Get medical advice/attention.
P312 Call a poison center/doctor if you feel unwell.
P321 Specific treatment (see on this label).
P332+P313 If skin irritation occurs: Get medical advice/attention.
P333+P313 If skin irritation or rash occurs: Get medical advice/attention.
P337+P313 If eye irritation persists: Get medical advice/attention.
P362+P364 Take off contaminated clothing and wash it before reuse.
P363 Wash contaminated clothing before reuse.
P403+P233 Store in a well-ventilated place. Keep container tightly closed.
P405 Store locked up.
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type Mixtures

Mixture of the substances listed below with nonhazardous additions.

Chemical Name CAS Number Concentration Hazardous
2-(2-methylprop-2-enoyloxy)ethyl 2-methylprop-2-enoate 25852-47-5 39.75% Yes
methacrylic acid, monoester with propane-1,2-diol 27813-02-1 20 - 29% Yes
2-Butenedioic acid (2E)-, polymer with a,a'-[(1-methylethylidene)di-4,1-phenylene]bis[w- hydroxypoly[oxy(methyl-1,2-ethanediyl)]] 39382-25-7 20 - 29% Yes
Amorphous Silica 67762-90-7 1 - 4% Yes
propane-1,2-diol 57-55-6 1 - 4% Yes
2'-phenylacetohydrazide 114-83-0 1% Yes
cumene 98-82-8 1% Yes
04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

In case of unconsciousness place patient stably in side position for transportation. Supply fresh air; consult doctor in case of complaints.

Skin contact

Immediately wash with water and soap and rinse thoroughly.

Eye contact

Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor.

Ingestion

If symptoms persist consult doctor.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

The data for this section has not been processed yet.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

The data for this section has not been processed yet.

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

The data for this section has not been processed yet.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Hands

Protective gloves The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation - Material of gloves The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Nitrile rubber, NBR - Penetration time of glove material The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.

Eyes

Tightly sealed goggles

Respiratory

Not required. In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use respiratory protective device that is independent of circulating air.

Skin/Body

Protective work clothing

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Explosive Limits
---
Melting Point
Undetermined.
Vapor Density
Not determined.
State Under Standard Conditions
---
Density
~ 1.06 g/cm3 (~ 8.8457 lbs/gal)
Evaporation Rate
Not determined.
Crystallisation Point
---
Colour Intensity
---
Boiling Point
≥ 200 °C (≥ 392 °F)
Ph
6
Bulk Density
---
Physical State
---
Relative Evaporation Rate
---
Odor Threshold
Not determined.
Softening Point
---
Partition Coefficient
Not determined.
Solubility In Fat
---
Solubility In Water
Not miscible or difficult to mix.
Relative Density
Not determined.
Decomposition Temperature
Not determined.
Molecular Weight
---
Vapor Pressure
≤ 0.1 hPa (≤0.1 mm Hg)
Odor
Characteristic
Upper Explosive Limit
Not determined.
Voc Content
1.17 % ~ 12.4 g/l / ~ 0.10 lb/gal
Freezing Point
---
Flammability
Not applicable.
Auto Ignition Temperature
n.a. ºC
Lower Explosive Limit
Not determined.
Kinematic Viscosity
Not determined.
Appearance
---
Form
Liquid
Dynamic Viscosity
1,800 mPas
Colour
Red
Flash Point
131 °C (267.8 ºF)
Solidification Point
---
Physical State Data
liquid
Properties Status
---
Metal Corrosion
---
Cloud Point
---
Solubility
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

The data for this section has not been processed yet.

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

The data for this section has not been processed yet.

14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
not regulated
Shipping Name
not regulated
Transport Class
not regulated
Packing Group
not regulated
15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

The data for this section has not been processed yet.

?

Frequently Asked Questions

Common questions about safety, handling, and properties

What other names is Vibra-TITE® Threadlocker known by?

Vibra-TITE® Threadlocker is also known as: 131 Permanent Strength Threadlocker

What is the hazard signal word for Vibra-TITE® Threadlocker?

The signal word is warning.

What is Vibra-TITE® Threadlocker used for?

Thread Locking

What are the hazard statements for Vibra-TITE® Threadlocker?

This substance has 5 hazard statements:

  • H315: Causes skin irritation.
  • H317: May cause an allergic skin reaction.
  • H319: Causes serious eye irritation.
  • H335: May cause respiratory irritation.
  • H351: Suspected of causing cancer.

What is the melting point of Vibra-TITE® Threadlocker?

The melting point is Undetermined. and the boiling point is ≥ 200 °C (≥ 392 °F).