ABSONET MULTISORB

Take the victim into open air; keep them warm and calm. If breathing is irregular or stops, perform artificial respiration.

Remove contaminated clothing.

Remove contact lenses, if present and if it is easy to do. Wash eyes with plenty of clean and cool water for at least 10 minutes while pulling eyelids up, and seek medical assistance.

Keep calm. NEVER induce vomiting.

Extinguisher powder or CO2. In case of more serious fires, also alcohol-resistant foam and water spray.

Do not use a direct stream of water to extinguish. In the presence of electrical voltage, you cannot use water or foam as extinguishing media.

Fire can cause thick, black smoke. Exposure to combustion or decomposition products can be harmful to your health.

Use water to cool tanks, cisterns, or containers close to the heat source or fire. Take wind direction into account.

Product not classified as hazardous for the environment, avoid spillage as much as possible.

The contaminated area should be immediately cleaned with an appropriate de-contaminator. Pour the decontaminator on the remains in an opened container and let it act various days until no further reaction is produced.

Materials: an appropriate de-contaminator

The product does not require special handling measures, the following general measures are recommended: For personal protection, see section 8. Never use pressure to empty the containers. They are not pressure-resistant containers. In the application area, smoking, eating, and drinking must be prohibited. Follow legislation on occupational health and safety. Keep the product in containers made of a material identical to the original.

The product does not require special storage measures. As general storage measures, sources of heat, radiation, electricity and contact with food should be avoided. Keep away from oxidising agents and from highly acidic or alkaline materials. Store the containers between 5 and 35º C, in a dry and well-ventilated place. Store according to local legislation. Observe indications on the label. The product is not affected by Directive 2012/18/EU (SEVESO III).

In the application area, smoking, eating, and drinking must be prohibited.

sources of heat, radiation, electricity and contact with food should be avoided.

Provide adequate ventilation, which can be achieved by using good local exhaust-ventilation and a good general exhaust system.

PPE: Protective gloves. Characteristics: «CE» marking, category II. CEN standards: EN 374-1, En 374-2, EN 374-3, EN 420. Maintenance: Keep in a dry place, away from any sources of heat, and avoid exposure to sunlight as much as possible. Do not make any changes to the gloves that may alter their resistance, or apply paints, solvents or adhesives. Observations: Gloves should be of the appropriate size and fit the user's hand well, not being too loose or too tight. Always use with clean, dry hands. Material: PVC (polyvinyl chloride). Breakthrough time (min.): > 480. Material thickness (mm): 0,35

PPE: Protective goggles against particle impacts. Characteristics: «CE» marking, category II. Eye protector against dust and smoke. CEN standards: EN 165, EN 166, EN 167, EN 168. Maintenance: Visibility through lenses should be ideal. Therefore, these parts should be cleaned daily. Protectors should be disinfected periodically following the manufacturer's instructions. Observations: Some signs of wear and tear include: yellow colouring of the lenses, superficial scratching of the lenses, scraping etc.

PPE: Particle filter mask. Characteristics: «CE» marking, category III. Made of filtering material, it covers nose, mouth and chin. CEN standards: EN 149. Maintenance: Check for any tears, defects, etc. before use. Since it is disposable individual protection equipment, it should be replaced after use. Observations: Does not protect worker unless properly adjusted. Follow the manufacturer's instructions regarding suitable use of the equipment. Filter Type needed: P2

PPE: Work footwear. Characteristics: «CE» marking, category II. CEN standards: EN ISO 13287, EN 20347. Maintenance: This product adapts to the first user's foot shape. That is why, as well as for hygienic reasons, it should not be used by other people. Observations: Work footwear for professional use includes protection elements aimed at protecting users against any injury resulting from an accident

Unstable in contact with: - Acids.

The product does not present hazards by their reactivity.

Neutralization can occur on contact with acids.

- Avoid contact with acids.

Avoid the following materials: - Acids.

No decomposition if used for the intended uses.

Do not dump into sewers or waterways. Waste and empty containers must be handled and eliminated according to current, local/national legislation. Follow the provisions of Directive 2008/98/EC regarding waste management.

Waste and empty containers must be handled and eliminated according to current, local/national legislation.