ManVer® 2 Hardness Indicator

Remove to fresh air.

Wash with soap and water. In the case of skin irritation or allergic reactions see a physician.

Symptoms: May cause an allergic skin reaction.

Rinse thoroughly with plenty of water for at least 15 minutes, lifting lower and upper eyelids. Consult a physician.

Clean mouth with water and drink afterwards plenty of water.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Caution: Use of water spray when fighting fire may be inefficient.

Product is or contains a sensitizer. May cause sensitization by skin contact.

Avoid contact with skin, eyes or clothing. Keep people away from and upwind of spill/leak. Ensure adequate ventilation. Use personal protective equipment as required. Evacuate personnel to safe areas.

See Section 12 for additional ecological information.

Take up mechanically, placing in appropriate containers for disposal.

In case of insufficient ventilation, wear suitable respiratory equipment. Do not eat, drink or smoke when using this product. Take off contaminated clothing and wash before reuse. Avoid contact with skin, eyes or clothing. Handle in accordance with good industrial hygiene and safety practice.

Keep containers tightly closed in a dry, cool and well-ventilated place. Store locked up. Keep out of the reach of children.

Do not eat, drink or smoke when using this product. Take off contaminated clothing and wash before reuse. Handle in accordance with good industrial hygiene and safety practice.

Showers, Eyewash stations, Ventilation systems.

Wear suitable gloves. Gloves must be inspected prior to use. The selected protective gloves have to satisfy the specifications of EU Directive 2016/425 and the standard EN 374 derived from it. Chemical resistant gloves made of butyl rubber or nitrile rubber category III according to EN 374-1:2016.

Wear safety glasses with side shields (or goggles).

No protective equipment is needed under normal use conditions. If exposure limits are exceeded or irritation is experienced, ventilation and evacuation may be required. Wear breathing apparatus if exposed to vapors/dusts/aerosols.

Wear suitable protective clothing.

Local authorities should be advised if significant spillages cannot be contained. Do not allow into any sewer, on the ground or into any body of water.

Stable under normal conditions.

Not applicable.

None under normal processing. Hazardous polymerization: None under normal processing.

None known based on information supplied.

Strong oxidizing agents, strong acids, and strong bases.

Hydrogen chloride. Sodium monoxide. Nitrogen oxides.

Dispose of in accordance with local regulations. Dispose of waste in accordance with environmental legislation.

Work in an approved fume hood. Dilute material with excess water making a weaker than 5% solution. Adjust to a pH between 6 and 9 with an alkali, such as soda ash or sodium bicarbonate. If permitted by regulation. Open cold water tap completely, slowly pour the reacted material to the drain. Allow cold water to run for 5 minutes to completely flush the system. Check with local municipal and state authorities and waste contractors for pertinent local information regarding the proper disposal of chemicals.