Testomat-Indikator Typ 303

Supply fresh air; consult doctor in case of complaints.

Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.

Rinse opened eye for several minutes under running water. Then consult a doctor.

A person vomiting while laying on their back should be turned onto their side. Rinse out mouth and then drink plenty of water. Seek medical treatment.

CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.

No further relevant information available.

Wear personal protection equipment.

Do not allow to enter sewers/ surface or ground water.

Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Clean the affected area carefully; suitable cleaners are: Warm water

Materials: sand, diatomite, acid binders, universal binders, sawdust

Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols.

Store only in the original receptacle. Keep container tightly sealed. Protect from heat and direct sunlight. Store receptacle in a well ventilated area.

No special measures required.

No further data; see item 7.

Wear gloves according to EN 374. The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Check protective gloves prior to each use for their proper condition. Preventive skin protection by use of skin-protecting agents is recommended. After use of gloves apply skin-cleaning agents and skin cosmetics. For the permanent contact gloves made of the following materials are suitable: Nitrile rubber, NBR. Recommended thickness of the material: ≥ 0.4 mm. Value for the permeation: Level = 6 (> 480 min). As protection from splashes gloves made of the following materials are suitable: Nitrile rubber, NBR. Recommended thickness of the material: ≥ 0.12 mm. Value for the permeation: Level = 2 (> 30 min).

Tightly sealed goggles according to EN 166

Not required.

Protective work clothing

Thermal decomposition / conditions to be avoided: Exothermic neutralisation reaction with acids. Under certain conditions possible formation of nitrosamines in the presence of nitrites or reagents causing nitrosation.

No further relevant information available.

No dangerous reactions known.

No further relevant information available.

Acids, nitrites, reagents causing nitrosation. Do not use tools made of aluminium or copper or their alloys.

Nitrogen oxides

Must not be disposed together with household garbage. Do not allow product to reach sewage system. Disposal must be made according to official regulations.

Must not be disposed together with household garbage. Do not allow product to reach sewage system. Disposal must be made according to official regulations.