Potassium nitrate for analysis EMSURE® ISO,Reag. Ph Eur

After inhalation: fresh air.

Take off immediately all contaminated clothing. Rinse skin with water/ shower.

After eye contact: rinse out with plenty of water. Remove contact lenses.

After swallowing: make victim drink water (two glasses at most). Consult doctor if feeling unwell.

Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

For this substance/mixture no limitations of extinguishing agents are given.

Nitrogen oxides (NOx), Potassium oxides, Not combustible. Fire may cause evolution of: nitrous gases, nitrogen oxides, Has a fire-promoting effect due to release of oxygen. Ambient fire may liberate hazardous vapours.

Suppress (knock down) gases/vapors/mists with a water spray jet.

Evacuate the danger area, observe emergency procedures, consult an expert.

Do not let product enter drains.

Take up dry. Clean up affected area.

Keep away from open flames, hot surfaces and sources of ignition.

Tightly closed. Do not store near combustible materials. Recommended storage temperature see product label.

Change contaminated clothing. Wash hands after working with substance.

Keep away from open flames, hot surfaces and sources of ignition.

Full contact: Material: Nitrile rubber, Minimum layer thickness: 0.11 mm, Break through time: 480 min, Material tested: KCL 741 Dermatril® L. Splash contact: Material: Nitrile rubber, Minimum layer thickness: 0.11 mm, Break through time: 480 min, Material tested: KCL 741 Dermatril® L. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN374 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).

Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses

required when dusts are generated. Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system. Recommended Filter type: Filter type P1. The entrepreneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer. These measures have to be properly documented.

protective clothing

Do not let product enter drains.

The product is chemically stable under standard ambient conditions (room temperature).

No data available

Risk of explosion with: Cyanides, Sulfides, combustible substances, Fluorine, Potassium, acetates, oxidisable substances, phosphides, Organic Substances, Peroxides, Aluminum, antimony, charcoal, Titanium, Zinc, Powdered metals, arsenic, Boron, Germanium, nitrides, magnesium, sodium thiosulphate, phosphorus, strong reducing agents, sulfur, sugars. Generates dangerous gases or fumes in contact with: Acids. Possible formation of: nitrogen dioxide. Risk of ignition or formation of inflammable gases or vapours with: calcium silicide.

no information available

No data available

In the event of fire: see section 5

Waste material must be disposed of in accordance with the national and local regulations.

Leave chemicals in original containers. No mixing with other waste.