SCP-700A Black (FD) Ink

Move affected person to fresh air and keep warm and at rest in a position comfortable for breathing. If breathing stops, provide artificial respiration. When breathing is difficult, properly trained personnel may assist affected person by administering oxygen. Get medical attention immediately.

Symptoms: May cause respiratory irritation. Vapour may affect central nervous system. Vapours may cause drowsiness and dizziness.

Remove contaminated clothing immediately and wash skin with soap and water. Get medical attention if irritation persists after washing. Wash clothing and clean shoes thoroughly before reuse.

Symptoms: Prolonged or repeated contact with skin may cause irritation, redness and dermatitis.

Rinse immediately with plenty of water. Continue to rinse for at least 15 minutes and get medical attention.

Symptoms: Severe irritation, burning, tearing and blurred vision. Prolonged contact causes serious eye and tissue damage.

Get medical attention immediately. Aspiration hazard if swallowed. Do not induce vomiting. Never give anything by mouth to an unconscious person. If vomiting occurs, the head should be kept low so that vomit does not enter the lungs. Entry into the lungs following ingestion or vomiting may cause chemical pneumonitis.

Symptoms: May cause nausea, headache, dizziness and intoxication. May cause stomach pain or vomiting.

Extinguish with alcohol-resistant foam, carbon dioxide, dry powder or water fog.

Water spray.

Flammable liquid and vapour. Vapours are heavier than air and may spread near ground and travel a considerable distance to a source of ignition and flash back.

Evacuate area. Stop leak if safe to do so. Use water to keep fire exposed containers cool and disperse vapours. Use water spray to reduce vapours.

Stop leak if safe to do so.

Use appropriate containment to avoid environmental contamination.

Collect and place in suitable waste disposal containers and seal securely.

Wear protective clothing as described in Section 8 of this safety data sheet.

Store at temperatures between 4.4°C/40°F and 32.2°C/90°F. Keep only in the original container in a cool, well-ventilated place. Protect from freezing and direct sunlight. Container must be kept tightly closed when not in use. Keep containers upright. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Store in accordance with national regulations.

Do not eat, drink or smoke when using this product. Provide eyewash station and safety shower. Good personal hygiene procedures should be implemented. Wash skin thoroughly after handling. Wash contaminated clothing before reuse.

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.

As this product contains ingredients with exposure limits, process enclosures, local exhaust ventilation or other engineering controls should be used to keep worker exposure below any statutory or recommended limits, if use generates dust, fumes, gas, vapour or mist. Use explosion-proof ventilating equipment.

It is recommended that chemical-resistant, impervious gloves are worn. The most suitable glove should be chosen in consultation with the glove supplier/manufacturer, who can provide information about the breakthrough time of the glove material. It is recommended that gloves are made of the following material: Butyl rubber. Nitrile rubber. Rubber (natural, latex). Frequent changes are recommended.

Wear tight-fitting, chemical splash goggles or face shield.

If ventilation is inadequate, suitable respiratory protection must be worn. Wear a respirator fitted with the following cartridge: Organic vapour filter.

Avoid contact with skin. Wear appropriate clothing to prevent repeated or prolonged skin contact.

Keep container tightly sealed when not in use.

Stable at normal ambient temperatures and when used as recommended.

There are no known reactivity hazards associated with this product.

The following materials may react with the product: Acids. Alkalis. Strong oxidising agents.

Avoid the following conditions: Heat, sparks, flames. Freezing.

Avoid contact with the following materials: Acids. Alkalis. Strong oxidising agents.

Heating may generate the following products: Carbon dioxide (CO2). Carbon monoxide (CO).

The generation of waste should be minimised or avoided wherever possible. When handling waste, the safety precautions applying to handling of the product should be considered. Dispose of waste to licensed waste disposal site in accordance with the requirements of the local Waste Disposal Authority. Dispose of waste product or used containers in accordance with local regulations Disposal of this product, process solutions, residues and by-products should at all times comply with the requirements of environmental protection and waste disposal legislation and any local authority requirements.

Dispose of contents/container in accordance with national regulations.