SIPMET 2, SIPMET 4, SIPMET 7, SIPMET 9, SIPMET 9R, SIPMET 12

If inhalation of mists, fumes or vapour causes irritation to the nose or throat, or coughing, remove to fresh air. Obtain medical advice if symptoms persist.

Symptoms: May be fatel if swallowed and enters airways

Wash skin thoroughly with soap and water after contact. Change contaminated clothing and dry-clean and launder before re-use.

Symptoms: No known significant effects or critical hazards.

Wash eyes thoroughly with copious quantities of water, ensuring eyelids are held open. Obtain medical advice if any pain or redness develops or persists.

Symptoms: No known significant effects or critical hazards.

If contamination of the mouth occurs, wash it out thoroughly with water. Obtain medical advice if large amounts are swallowed - do not induce vomiting.

Symptoms: No known significant effects or critical hazards.

No special requirements under ordinary conditions of use and with adequate ventilation.

Any specific glove information provided is based on published literature and glove manufacturer data. Glove suitability and breakthrough time will differ depending on the specific use conditions. Contact the glove manufacturer for specific advice on glove selection and breakthrough times for your use conditions. Inspect and replace worn or damaged gloves. The types of gloves to be considered for this material include: Nitrile rubber/Nitrile latex - NBR (0,35 mm) Fluoro carbon rubber - FKM (0,4 mm) Following materials are unsuitable for protective gloves: Natural rubber/Natural latex - NR Polychloroprene - CR Butyl rubber - Butyl Polyvinyl chloride - PVC

If contact is likely, safety glasses with side shields are recommended.

If engineering controls do not maintain airborne contaminant concentrations at a level which is adequate to protect worker health, an approved respirator may be appropriate. Respirator selection, use, and maintenance must be in accordance with regulatory requirements, if applicable. Types of respirators to be considered for this material include: No special requirements under ordinary conditions of use and with adequate ventilation. For high airborne concentrations, use an approved supplied-air respirator, operated in positive pressure mode. Supplied air respirators with an escape bottle may be appropriate when oxygen levels are inadequate, gas/vapour warning properties are poor, or if air purifying filter capacity/rating may be exceeded.

No skin protection is ordinarily required under normal conditions of use. In accordance with good industrial hygiene practices, precautions should be taken to avoid skin contact.

Comply with applicable environmental regulations limiting discharge to air, water and soil. Protect the environment by applying appropriate control measures to prevent or limit emissions.