Calcined Kaolin, Chamotte

In case of accident by inhalation: remove casualty to fresh air and keep at rest. In case of respiratory tract irritation, consult a physician.

Gently wash with plenty of soap and water. In case of skin irritation, seek medical treatment.

Rinse cautiously with water for several minutes. In case of troubles or persistent symptoms, consult an ophthalmologist.

Rinse mouth thoroughly with water. Let water be drunken in little sips (dilution effect). Do NOT induce vomiting. In all cases of doubt, or when symptoms persist, seek medical advice.

The product itself does not burn.

High power water jet.

No information available.

Co-ordinate fire-fighting measures to the fire surroundings.

General advice: Avoid dust formation. Do not breathe dust. For non-emergency personnel: Wear personal protection equipment (refer to section 8). For emergency responders: No special measures are necessary.

Discharge into the environment must be avoided.

Clean contaminated objects and areas thoroughly observing environmental regulations.

Wear personal protection equipment (refer to section 8). Always close containers tightly after the removal of product. Do not eat, drink, smoke or sneeze at the workplace. Wash hands before breaks and after work.

Keep container tightly closed in a cool, well-ventilated place. Keep the packing dry and well sealed to prevent contamination and absorption of humidity. Protect against: frost. UV-radiation/sunlight. heat. Humidity.

Do not eat, drink, smoke or sneeze at the workplace. Wash hands before breaks and after work.

Usual measures for fire prevention.

Technical measures and the application of suitable work processes have priority over personal protection equipment. Dust should be exhausted directly at the point of origin.

In case of prolonged or frequently repeated skin contact: Wear suitable gloves. Suitable material: FKM (fluororubber). - Thickness of glove material: 0,4 mm Breakthrough time >= 8 h. Butyl rubber. - Thickness of glove material: 0,5 mm Breakthrough time >= 8 h. CR (polychloroprenes, Chloroprene rubber). - Thickness of glove material: 0,5 mm Breakthrough time >= 8 h. NBR (Nitrile rubber). - Thickness of glove material: 0,35 mm Breakthrough time >= 8 h. PVC (Polyvinyl chloride). - Thickness of glove material: 0,5 mm Breakthrough time >= 8 h. The selected protective gloves have to satisfy the specifications of EU Directive EC/2016/425 and the standard EN ISO 374 derived from it. Before using check leak tightness / impermeability. In the case of wanting to use the gloves again, clean them before taking off and air them well.

Dust protection goggles.

With correct and proper use, and under normal conditions, breathing protection is not required. Respiratory protection necessary at: - Exceeding exposure limit values - Insufficient ventilation and Generation/formation of dust. Suitable respiratory protective equipment: particulates filter device (DIN EN 143). Type: P1-3. The filter class must be suitable for the maximum contaminant concentration (gas/vapour/aerosol/particulates) that may arise when handling the product. If the concentration is exceeded, self-contained breathing apparatus must be used.

Suitable protective clothing: Protective clothing. Minimum standard for preventive measures while handling with working materials are specified in the TRGS 500 (D).

No special precautionary measures are necessary.

The product is chemically stable under recommended conditions of storage, use and temperature.

No information available.

No hazardous reaction when handled and stored according to provisions. Refer to chapter 10.5.

No information available.

No information available.

Does not decompose when used for intended uses.

Consult the local waste disposal expert about waste disposal.

Observe in addition any national regulations! Consult the local waste disposal expert about waste disposal.