BP30

Provide fresh air.

Remove contaminated, saturated clothing immediately. In case of skin contact, wash immediately with large quantities of water/polyethylene glycol. In case of skin irritation, consult a physician.

Symptoms: Causes skin irritation.

In case of contact with eyes flush immediately with plenty of flowing water for 10 to 15 minutes holding eyelids apart and consult an ophthalmologist. Remove contact lenses, if present and easy to do. Continue rinsing.

Symptoms: Causes serious eye irritation.

Rinse mouth immediately and drink plenty of water. Do NOT induce vomiting. Get immediate medical advice/attention.

Water spray jet, alcohol resistant foam, extinguishing powder, carbon dioxide (CO2). Co-ordinate firefighting measures to the fire surroundings.

Strong water jet

The product itself does not burn.

Co-ordinate firefighting measures to the fire surroundings.

Provide adequate ventilation. Avoid contact with skin, eyes and clothes. Remove persons to safety.

Do not allow to enter into surface water or drains. Do not allow to enter into soil/subsoil.

Wash with plenty of water.

Provide adequate ventilation. Do not breathe gas/vapour/aerosol. Avoid: generation/formation of aerosols. Avoid contact with skin, eyes and clothes. After contact with Metal: May be corrosive to metals. Wear personal protection equipment (refer to section 8).

Store in a well-ventilated place. Keep container tightly closed. Material, acid-resistant. Keep/Store only in original container. Keep in a cool, well-ventilated place away from alkali. Keep away from food, drink and animal feedingstuffs. Protect from sunlight.

When using do not eat, drink or smoke. Take off contaminated clothing and wash it before reuse. Avoid contact with eyes and skin. Wash hands and face before breaks and after work and take a shower if necessary. Draw up and observe skin protection programme.

The product is not: Combustible.

Technical measures and the application of suitable work processes have priority over personal protection equipment. Generation/formation of aerosols: Devices with local exhaust / Technical ventilation of workplace

Tested protective gloves must be worn (EN ISO 374). Suitable material: NBR (Nitrile rubber). Thickness of the glove material: ≥ 0,4 mm. Breakthrough time:: ≥ 480 min. The statement is derived from the properties of the main components. The suitability of the glove material for the handling of the product has not been verified. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned above together with the supplier of these gloves. The quality of the protective gloves resistant to chemicals must be chosen as a function of the specific working place concentration and quantity of hazardous substances. Check leak tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off and air them well.

Eye glasses with side protection (EN 166).

Usually no personal respirative protection necessary. Provide adequate ventilation. Wear breathing apparatus if exposed to vapours/dusts/aerosols. Combination filtering device, Filtering device (full mask or mouthpiece) with filter: P2

Wear suitable protective clothing.

No data available.

The product is chemically stable under recommended conditions of storage, use and temperature.

The product is: acidic.

No hazardous reaction when handled and stored according to provisions. Exothermic reaction with: alkali (lye). May be corrosive to metals.

No data available.

oxidizing agent, alkali (lye).

No known hazardous decomposition products. In case of fire may be liberated: phosphorus oxides (PxOy).

Dispose of waste according to applicable legislation. Consult the appropriate local waste disposal expert about waste disposal.

Dispose of waste according to applicable legislation. Consult the appropriate local waste disposal expert about waste disposal.

Remark: -

not determined

not determined