Yunio milk system cleaner

Remove casualty to fresh air and keep warm and at rest. Provide fresh air. When in doubt or if symptoms are observed, get medical advice.

Take off immediately all contaminated clothing. Rinse skin with water/shower. If skin irritation occurs: Get medical advice/attention.

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. In case of eye irritation consult an ophthalmologist.

If swallowed, rinse mouth with water (only if the person is conscious). Keep victim calm. Do NOT induce vomiting. Call a physician immediately. If medical advice is needed, have product container or label at hand.

Extinguishing powder, Carbon dioxide (CO2), spray mist, (water)

strong water jet

Inhaling hazardous decomposing products can cause serious health damage.

Do not allow to enter into surface water or drains. If the product contaminates lakes, rivers or sewages, inform competent authorities in accordance with local regulations.

Isolate leaked material using non-flammable absorption agent and collect it for disposal in appropriate containers in accordance with the local regulations (see section 13). Treat the recovered material as prescribed in the section on waste disposal. Provide adequate ventilation.

Materials: non-flammable absorption agent (e.g. sand, earth, vermiculit, diatomaceous earth)

Keep container tightly closed. Do not empty containers with pressure - no pressure vessel! Smoking is forbidden. Access only for authorised persons. Store carefully closed containers upright to prevent any leaks.

Stable when applying recommended regulations for storage and handling. Store in a well-ventilated and dry room at temperatures between 5 °C and 30 °C. Protect from heat and direct sunlight. Keep container tightly closed and upright to prevent any leaks. Remove all sources of ignition. Smoking is forbidden. Access only for authorised persons. Do not empty containers with pressure - no pressure vessel!

Smoking is forbidden.

Smoking is forbidden. Remove all sources of ignition.

Provide good ventilation. This can be achieved with local or room suction.

For prolonged or repeated handling the following glove material must be used: NBR (Nitrile rubber) Thickness of the glove material 0,4 mm Breakthrough time: 30 min. Observe the instructions and details for use, storage, maintenance and replacement provided by the protective glove manufacturer. Penetration time of glove material depending on intensity and duration of exposure to skin: Recommended glove articles EN ISO 374.

Wear closely fitting protective glasses in case of splashes.

Not applicable. Suitable respiratory protection apparatus: Respiratory protection is required for not sufficiently ventilated working places and during the spraying processing.

Wear suitable protective clothing and gloves.

Do not allow to enter into surface water or drains. See section 7. No additional measures necessary.

Stable when applying the recommended regulations for storage and handling.

No information available. No hazardous reaction when handled and stored according to provisions.

Keep away from strong acids, strong bases and strong oxidizing agents to avoid exothermic reactions.

Stable when applying the recommended regulations for storage and handling. Further information on correct storage: refer to section 7. Hazardous decomposition byproducts may form with exposure to high temperatures.

not applicable

noneThermal decomposition can lead to the escape of irritating gases and vapours. Hazardous decomposition byproducts may form with exposure to high temperatures.

Waste disposal according to directive 2008/98/EC, covering waste and dangerous waste.

Do not allow to enter into surface water or drains. This material and its container must be disposed of in a safe way.