MR® 79 Special Cleaner

Supply fresh air; consult doctor in case of complaints.

If skin irritation continues, consult a doctor. Immediately wash with water and soap and rinse thoroughly.

Rinse opened eye for several minutes under running water. Then consult a doctor.

Not relevant - aerosol can.

CO2, powder or water spray. Fight larger fires with water spray or alcohol resistant foam.

Water with full jet

In case of fire, the following can be released: Carbon monoxide (CO)

Wear protective equipment. Keep unprotected persons away.

Do not allow to enter sewers/ surface or ground water.

Dispose contaminated material as waste according to item 13.

No special precautions are necessary if used correctly.

Store in a cool location. Observe official regulations on storing packagings with pressurised containers. Protect from heat and direct sunlight.

Do not spray onto a naked flame or any incandescent material. Keep ignition sources away - Do not smoke.

Additional information about design of technical facilities: No further data; see item 7. For good ventilation provide, this can be achieved by local or space exhaust.

Check the permeability prior to each anewed use of the glove. For the protection against chemicals in areas with heightened risk of injury (mechanical hazard) no recommendation for a suitable glove material can be given. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation. Material of gloves: Butyl rubber, BR. Recommended thickness of the material: $\geq 0.7 \pm 0.1 \mathrm{~mm}$. The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. Penetration time of glove material: Value for the permeation: Level $\leq 6$. The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed.

Safety glasses

Filter AX. For good ventilation provide, this can be achieved by local or space exhaust. If the concentration lies over the job limit values, then, a certified respirator suitable for this purpose must be used.

Protective work clothing

Thermal decomposition / conditions to be avoided: Danger of bursting of the aerosol can during overheating

No further relevant information available.

No dangerous reactions known.

No further relevant information available.

No further relevant information available.

No dangerous decomposition products known.

Must not be disposed together with household garbage. Do not allow product to reach sewage system.

Eliminate in accordance with local regulations.

Warning: Gases.

SW1 Protected from sources of heat. SW22 For AEROSOLS with a maximum capacity of 1 litre: Category A. For AEROSOLS with a capacity above 1 litre: Category B. For WASTE AEROSOLS: Category C, Clear of living quarters. SG69 For AEROSOLS with a maximum capacity of 1 litre: Segregation as for class 9. Stow "separated from" class 1 except for division 1.4. For AEROSOLS with a capacity above 1 litre: Segregation as for the appropriate subdivision of class 2. For WASTE AEROSOLS: Segregation as for the appropriate subdivision of class 2.

Warning: Gases.