PLASITE 4301 HT PART A

Move to fresh air. Consult a physician after significant exposure.

Use a mild soap if available. Wash off immediately with soap and plenty of water while removing all contaminated clothes and shoes. If skin irritation persists, call a physician.

Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Remove contact lenses.

Gently wipe or rinse the inside of the mouth with water. Give small amounts of water to drink. Do NOT induce vomiting. Never give anything by mouth to an unconscious person.

Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.

Alcohol, Alcohol based solutions, any other media not listed above. Do not use a solid water stream as it may scatter and spread fire.

Flash back possible over considerable distance.

In the event of fire, wear self-contained breathing apparatus.

Ensure adequate ventilation. Use personal protective equipment. Remove all sources of ignition.

Do not allow material to contaminate ground water system. Prevent product from entering drains.

soak up with non-combustible absorbent material and transfer to a container for disposal according to local / national regulations

Materials: non-combustible absorbent material (e.g. sand, earth, diatomaceous earth, vermiculite)

Take necessary action to avoid static electricity discharge (which might cause ignition of organic vapours). Vapours may form explosive mixtures with air. Prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentration higher than the occupational exposure limits. Wear personal protective equipment. Do not breathe vapours or spray mist. Keep away from sources of ignition - No smoking.

Store in original container. Keep locked up or in an area accessible only to qualified or authorised persons. Store in a dry, well ventilated place away from sources of heat, ignition and direct sunlight.

Wash hands before breaks and at the end of workday. When using, do not eat, drink or smoke.

Take necessary action to avoid static electricity discharge. Keep away from sources of ignition - No smoking. All metal parts of the equipment must be grounded.

Ensure adequate ventilation, especially in confined areas.

Impervious gloves. Take note of the information given by the producer concerning permeability and break through times, and of special workplace conditions (mechanical strain, duration of contact).

Tightly fitting safety goggles.

Respirator with a vapor filter.

Long sleeved clothing. Remove and wash contaminated clothing before re-use.

Stable under recommended storage conditions. Risk of ignition.

No reactivity hazards known under normal storage and use conditions.

Hazardous polymerisation does not occur.

Direct sources of heat.

Strong oxidizing agents.

Carbon dioxide (CO2), carbon monoxide (CO), oxides of nitrogen (NOx), dense black smoke.

Do not burn, or use a cutting torch on, the empty drum. If recycling is not practicable, dispose of in compliance with local regulations.

Empty containers should be taken to an approved waste handling site for recycling or disposal.