Belticryl 2-pack paint

Remove to fresh air, keep patient warm and at rest. If breathing is irregular or stopped, administer artificial respiration.

Remove contaminated clothing. Wash skin thoroughly with soap and water or use recognised skin cleanser. Do NOT use solvents or thinners.

Remove contact lenses, irrigate copiously with clean, fresh water, holding the eyelids apart and seek medical advice.

If accidentally swallowed obtain immediate medical attention. Keep at rest. DO NOT induce vomiting.

alcohol resistant foam, CO₂, powders, water spray

Waterjet

Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard.

Cool closed containers exposed to fire with water.

Exclude sources of ignition and ventilate the area. Avoid breathing vapours. Refer to protective measures listed in sections 7 and 8.

Do not allow to enter drains or water courses. If the product contaminates lakes, rivers or sewage, inform appropriate authorities in accordance with local regulations.

Clean preferably with a detergent; avoid the use of solvents.

Materials: detergent

Vapours are heavier than air and may spread along floors. Vapours may form explosive mixtures with air. Prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentration higher than the occupational exposure limits. Keep container tightly closed. Isolate from sources of heat, sparks and open flame. No sparking tools should be used. Avoid skin and eye contact. Avoid the inhalation of dust, particulates and spray mist arising from the application of this preparation. Avoid inhalation of dust from sanding. Never use pressure to empty: container is not a pressure vessel.

Store between 10° and 30°C in a dry, well ventilated place away from sources of heat and direct sunlight.

Smoking, eating and drinking should be prohibited in application area.

Exclude all naked lights and other sources of ignition. Keep away from sources of ignition. No smoking.

Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction.

For prolonged or repeated contact: use hand gloves (solvent resistant). The instructions and information provided by the glove manufacturer on use, storage, maintenance and replacement must be followed. Barrier creams may help to protect the exposed areas of the skin, they should however not be applied once exposure has occurred.

Use safety eyewear designed to protect against splash of liquids.

If these are not sufficient to maintain concentrations of particulates and solvent vapour below the occupational exposure limits (OEL), suitable respiratory protection must be worn. If workers are exposed to concentrations above the exposure limit they must use appropriate, certified respirators.

Personnel should wear anti-static clothing made of natural fibre or of high temperature resistant synthetic fibre.

Stable under recommended storage and handling conditions (see section 7).

exothermic reactions

high temperatures

oxidising agents, strongly alkaline and strongly acid materials

carbon monoxide and dioxide, smoke, oxides of nitrogen, etc.

Wastes and emptied containers should be treated like chemical waste.