SÜDWEST 2K-Acryl-Seidenglanzlack

Move to fresh air in case of accidental inhalation of vapours or decomposition products. Keep patient warm and at rest. If breathing is irregular or stopped, administer artificial respiration. If symptoms persist, call a physician.

Symptoms: irritant effects, Headache, Vertigo, Drowsiness, Unconsciousness

Take off contaminated clothing and shoes immediately. Wash skin thoroughly with soap and water or use recognized skin cleanser. Do NOT use solvents or thinners. If skin irritation persists, call a physician.

In case of eye contact, remove contact lens and rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Seek medical advice.

Rinse mouth with water. If swallowed, seek medical advice immediately and show this container or label. Keep at rest. Do NOT induce vomiting.

CO2, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam.

High volume water jet

Fire may cause evolution of: Carbon monoxide, Carbon dioxide (CO2), Nitrogen oxides (NOx). Exposure to decomposition products may be a hazard to health.

Cool closed containers exposed to fire with water spray.

Remove all sources of ignition. Ensure adequate ventilation. Do not breathe vapour. Prevent unauthorized access.

The product should not be allowed to enter drains, water courses or the soil.

collect with non-combustible absorbent material and place in container for disposal according to local / national regulations. Clean with detergents. Avoid solvents. Clean contaminated surface thoroughly.

Materials: detergents

Comply with the statutory regulations on health and safety at work. Avoid formation of aerosol. Prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour concentration higher than the occupational exposure limit values. The product should only be used in areas from which all naked lights and other sources of ignition have been excluded. All metal parts of the mixing and processing equipment must be earthed. Operators should wear antistatic footwear and clothing. No sparking tools should be used.

Store in original container. Keep container tightly closed. Never use pressure to empty: container is not a pressure vessel. No smoking. Prevent unauthorized access. Containers which are opened must be carefully resealed and kept upright to prevent leakage. Protect from frost, heat and sunlight.

Do not breathe spray, vapour. Take off immediately all contaminated clothing. Avoid contact with skin, eyes and clothing. Wash hands before breaks and immediately after handling the product. After washing hands, replenish lost skin oil by means of oily skin ointment. When using do not eat, drink or smoke.

The product should only be used in areas from which all naked lights and other sources of ignition have been excluded. All metal parts of the mixing and processing equipment must be earthed. Operators should wear antistatic footwear and clothing. No sparking tools should be used.

Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. If these are not sufficient to maintain concentrations of particulates solvent vapour below the occupational exposure limit values, suitable respiratory - protection must be worn.

Recommended preventive skin protection. Before starting work, apply water-resistant skincare preparations to exposed skin areas. Protective gloves should be worn in case of skin contact during preparation and application. Break through time: 480 min. Minimum thickness: 0,4 mm. Gloves made of nitrile rubber, e.g. KCL 730 Camatril® Velours (Kächele-Cama-Latex GmbH, Hotline: 0049(0)6659-87-300, kcl-uk@kcl.de), or equivalent. Skin that comes into contact with the product should be treated with protective cream. After such contact, the product concerned should under no circumstances be used. The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it. The choice of an appropriate glove does not only depend on its material but also on other quality features and is different from one producer to the other.

Safety glasses with side-shields conforming to EN166

For brief exposure or low level concentrations use a respiratory filter; for more intense or longer exposure use a self-contained respiratory protective device. Respiratory filter for brief exposure: Combination filter A-P2. Respiratory protection complying with EN 14387.

Preventive skin protection. Long sleeved clothing. Personal should wear antistatic clothings made of natural fiber or of high temperature resistant synthetic fiber. All parts of the body should be washed after contact.

The product should not be allowed to enter drains, water courses or the soil. If the product contaminates rivers and lakes or drains inform respective authorities.

Stable under normal conditions.

No dangerous reaction known under conditions of normal use.

No dangerous reaction known under conditions of normal use. Vapours may form explosive mixture with air.

Direct sources of heat. Strong sunlight for prolonged periods.

Strong acids and strong bases, Strong oxidizing agents

No decomposition if stored and applied as directed.

Fluid remains should be taken to a local waste disposal site.

Partial and residual quantities can be reused.