NextSDS Logo
Safety Data Sheet EN

BIGUMA - SWS

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report.

Get Free Audit
01

Identification

Product identifiers, regulatory numbers, and supplier information

Product Information

Product Name
BIGUMA - SWS
Product Form
foam aerosol

Regulatory Identifiers

CAS Number
N/A

Identified Uses

Washing and cleaning products (including solvent based products). The product is a foam aerosol.

Manufacturers & Suppliers

dortmunder gußasphalt gmbh & co. kg logo

dortmunder gußasphalt gmbh & co. kg

manufacturer

Am Hafenbahnhof 10, D-44147 Dortmund

+49(0) 23 1 39 57 97-0

http://www.dga.de

Dr. Gans-Eichler Chemieberatung GmbH logo

Dr. Gans-Eichler Chemieberatung GmbH

Raesfeldstr. 22, D-48149 Münster

+49 (0)251/924520-60

http://www.tge-consult.de

Emergency Contacts

Poison Information Center Mainz, Germany

+49 (6131) 19240

02

Hazard Identification

GHS classification, signal word, pictograms, and hazard statements

Classified danger

Hazard Classifications

Aerosol Cat. 1
Skin Irrit. Cat. 2
Eye Dam. Cat. 1
Skin Sens. Cat. 1
Aquatic Chronic Cat. 2

GHS Pictograms

GHS02 - Flammable

GHS02

GHS05 - Corrosive

GHS05

GHS07 - Health hazard

GHS07

GHS09 - Environmental hazard

GHS09

Hazard Statements

H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H318 Causes serious eye damage.
H411 Toxic to aquatic life with long lasting effects.

Precautionary Statements

P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P261 Avoid breathing dust/fume/gas/mist/vapours/spray.
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P310 Immediately call a POISON CENTER/doctor.
P410 + P412 Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
P501 Dispose of contents/container to in accordance with official regulations.

Get a free compliance audit

Upload your SDS inventory and get a detailed compliance report

Free Audit
03

Composition / Information on Ingredients

Chemical components, concentration ranges, and hazardous substance identification

Type mixture

>= 30 % aliphatic hydrocarbons, perfumes, < 5 % anionic surfactants, < 5 % non-ionic surfactants.

Chemical Name CAS Number Concentration Hazardous
HYDROCARBONS, C11-C12,. ISOALKANES, <2% AROMATICS. EC: 918-167-1 --- 45 - 50% Yes
orange oil terpenes EC: 232-433-8 68647-72-3 5 - 10% Yes
dodecylbenzenesulphonic acid, compound with 1-aminopropan-2-ol (1:1) EC: 255-854-9 42504-46-1 1 - 5% Yes
Alcohols, C12-14, ethoxylated EC: 500-213-3 68439-50-9 1 - 5% Yes
Docusate sodium (sodium 1,4-bis[(2-ethylhexyl)oxy]-1,4-dioxobutane-2-sulfonate) EC: 209-406-4 577-11-7 1 - 5% Yes

Product does not contain listed SVHC substances > 0,1 % according to Regulation (EC) No. 1907/2006 Article 59 (REACH)

04

First Aid Measures

Emergency procedures for chemical exposure incidents

Inhalation

In case of accident by inhalation: remove casualty to fresh air and keep at rest. If unconscious place in recovery position and seek medical advice. In case of irregular breathing or respiratory arrest provide artificial respiration. In case of allergic symptoms, especially in the breathing area, seek medical advice immediately.

Symptoms: Headache. drowsiness. unconsciousness.

Skin contact

After contact with skin, wash immediately with plenty of water and soap. Take off immediately all contaminated clothing. In case of skin irritation, seek medical treatment.

Symptoms: dehydration of skin.

Eye contact

Rinse immediately carefully and thoroughly with eye-bath or water. In case of troubles or persistent symptoms, consult an ophthalmologist.

Ingestion

Rinse mouth thoroughly with water. Let water be drunken in little sips (dilution effect). Do NOT induce vomiting. Call a physician immediately.

Medical Treatment

Treat symptomatically.

05

Firefighting Measures

Extinguishing media, specific hazards, and firefighter protection

Suitable media

Carbon dioxide (CO2). Dry extinguishing powder. alcohol resistant foam. Atomized water.

Unsuitable media

High power water jet.

Specific hazards

In use, may form flammable/explosive vapour-air mixture. Concentrated vapours are heavier than air. Reignition possible over considerable distance.

Instructions

Co-ordinate fire-fighting measures to the fire surroundings.

Firefighter Protection

Wear a self-contained breathing apparatus and chemical protective clothing. In case of fire and/or explosion do not breathe fumes.

06

Accidental Release Measures

Spill cleanup procedures, containment, and environmental protection

Emergency procedures

Ventilate affected area. Remove all sources of ignition. Do not breathe gas/fumes/vapour/spray. Avoid contact with skin, eyes and clothes.

Environmental

Do not allow to enter into surface water or drains. Due to danger of explosion, prevent leakage of vapours into cellars, flues and ditches. Prevent spread over a wide area (e.g. by containment or oil barriers).

Cleanup methods

Absorb with liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents). Clean contaminated objects and areas thoroughly observing environmental regulations.

Materials: liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents)

Related Products

Similar products with comparable safety profiles

07

Handling and Storage

Safe handling precautions, storage conditions, and workplace requirements

Handling

Use only in well-ventilated areas. Do not spray on naked flames or any incandescent material. Due to danger of explosion, prevent leakage of vapours into cellars, flues and ditches.

Storage

Keep/Store only in original container. Keep container tightly closed in a cool, well-ventilated place. Ensure adequate ventilation of the storage area.

Fire prevention

Keep away from sources of ignition. - No smoking. Heating causes rise in pressure with risk of bursting.

08

Exposure Controls / PPE

Occupational exposure limits, engineering controls, and protective equipment

Engineering

If local exhaust ventilation is not possible or not sufficient, the entire working area should be ventilated by technical means.

Hands

Pull-over gloves of rubber. Suitable material: NBR (Nitrile rubber). FKM (fluororubber). The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and the standard EN 374 derived from it. Before using check leak tightness / impermeability. In the case of wanting to use the gloves again, clean them before taking off and air them well.

Eyes

Wear safety glasses; chemical goggles (if splashing is possible).

Respiratory

With correct and proper use, and under normal conditions, breathing protection is not required. Respiratory protection necessary at: exceeding exposure limit values, insufficient ventilation. short term (single use).: Suitable respiratory protective equipment: Combination filter device (DIN EN 141).. Type A/P3. Long Term (continuous): Suitable respiratory protective equipment: Protective respiration apparatus not using surrounding air (breathing apparatus) (DIN EN 133). Use only respiratory protection equipment with CE-symbol including four digit test number. Observe the wear time limits according GefStoffV in combination with the rules for using respiratory protection apparatus (BGR 190). The filter class must be suitable for the maximum contaminant concentration (gas/vapour/aerosol/particulates) that may arise when handling the product. If the concentration is exceeded, closed-circuit breathing apparatus must be used!

Skin/Body

Protective clothing.

Environmental

Do not allow to enter into surface water or drains.

09

Physical and Chemical Properties

Appearance, physical state, melting point, boiling point, and material characteristics

Melting Point
not determined
Evaporation Rate
---
Appearance
---
Boiling Point
not determined
Ph
not determined
Softening Point
---
Density
0,8 g/cm³
Cloud Point
---
Lower Explosive Limit
0,6 vol. %
Partition Coefficient
---
Crystallisation Point
---
Bulk Density
---
Vapor Pressure
not determined
Dynamic Viscosity
not determined
Solubility
miscible with most organic solvents
Solubility In Water
not miscible
Voc Content
---
Colour Intensity
---
Solubility In Fat
---
Form
---
Physical State Data
aerosol
Odor Threshold
---
Odor
characteristic
Flash Point
< 0 °C
Auto Ignition Temperature
not determined
Properties Status
---
Metal Corrosion
---
Explosive Limits
---
Molecular Weight
---
Upper Explosive Limit
9,0 vol. %
Colour
light yellow
Relative Evaporation Rate
---
Freezing Point
---
Kinematic Viscosity
---
Vapor Density
---
Solidification Point
---
Relative Density
---
Decomposition Temperature
---
Physical State
Aerosol
State Under Standard Conditions
---
Flammability
---
10

Stability and Reactivity

Chemical stability, hazardous reactions, and incompatible materials

Stability

Stable under normal storage and handling conditions.

Reactivity

No information available.

Hazardous reactions

No information available.

Avoid

Keep away from heat. Protect against direct sunlight. Keep away from sources of ignition. - No smoking. Take precautionary measures against static discharges.

Incompatible

miscible with most organic solvents

Decomposition

Can be released in case of fire: Carbon monoxide Carbon dioxide (CO2).

12

Ecological Information

Environmental toxicity, biodegradation, and bioaccumulation data

The data for this section has not been processed yet.

13

Disposal Considerations

Waste treatment methods, disposal recommendations, and waste codes

Treatment

Dispose of waste according to applicable legislation. Consult the local waste disposal expert about waste disposal.

Disposal

Consult the local waste disposal expert about waste disposal.

Waste Codes

160504 gases in pressure containers (including halons) containing hazardous substances EWC
150110 packaging containing residues of or contaminated by hazardous substances EWC
14

Transport Information

UN numbers, shipping names, transport classes, and regulatory requirements

UN Number
UN 1950
Shipping Name
AEROSOLS
Packing Group
III
IMDG

63, 190, 277, 327, 344, 959

15

Regulatory Information

Chemical regulations, safety assessments, and compliance status

Chemical Safety Assessment Not performed
?

Frequently Asked Questions

Common questions about safety, handling, and properties

What is the hazard signal word for BIGUMA - SWS?

The signal word is danger.

What is the physical form of BIGUMA - SWS?

BIGUMA - SWS is a aerosol with light yellow color. It has characteristic odor.

What is the solubility of BIGUMA - SWS?

miscible with most organic solvents

What is BIGUMA - SWS used for?

Washing and cleaning products (including solvent based products). The product is a foam aerosol.

What are the hazard statements for BIGUMA - SWS?

This substance has 6 hazard statements:

  • H222: Extremely flammable aerosol.
  • H229: Pressurised container: May burst if heated.
  • H315: Causes skin irritation.
  • H317: May cause an allergic skin reaction.
  • H318: Causes serious eye damage.
  • H411: Toxic to aquatic life with long lasting effects.

What is the melting point of BIGUMA - SWS?

The melting point is not determined and the boiling point is not determined.